openwrt/target/linux/ath79
Petr Štetiar 40530c8eb4 ath79: Add support for Ubiquiti Nanostation M (XW)
CPU:  AR9342 SoC
RAM:      64 MB DDR2
Flash:     8 MB NOR SPI
Ports: 2x100 MBit (24V PoE in, 24V PoE out), AR8236 switch
WLAN:  2.4/5 GHz
UART:      1 UART
LEDs:        Power, 2x Ethernet, 4x RSSI LEDs (orange, red, 2x green)
Buttons:     Reset

Flashing instructions using recovery method over TFTP

 1. Unplug the ethernet cable from the router.
 2. Using paper clip press and hold the router's reset button. Make sure
    you can feel it depressed by the paper clip. Do not release the button
    until step 4.
 3. While keeping the reset button pressed in, plug the ethernet cable
    back into the AP. Keep the reset button depressed until you see the
    device's LEDs flashing in upgrade mode (alternating LED1/LED3 and
    LED2/LED4), this may take up to 25 seconds.
 4. You may release the reset button, now the device should be in TFTP
    transfer mode.
 5. Set a static IP on your Computer's NIC. A static IP of 192.168.1.25/24
    should work.
 6. Plug the PoE injector's LAN cable directly to your computer.
 7. Start tftp client and issue following commands:
     tftp> binary
     tftp> connect 192.168.1.20
     tftp> put openwrt-ath79-generic-ubnt-nano-m-xw-squashfs-factory.bin

Tested-by: Joe Ayers <ae6xe@arrl.net>
Signed-off-by: Petr Štetiar <ynezz@true.cz>
2019-03-05 03:15:52 +01:00
..
base-files ath79: Add support for Ubiquiti Nanostation M (XW) 2019-03-05 03:15:52 +01:00
dts ath79: Add support for Ubiquiti Nanostation M (XW) 2019-03-05 03:15:52 +01:00
files ath79: gmac: ar934x: Add parser for mii-gmac0-slave 2019-03-05 03:15:52 +01:00
generic ath79: add support for devolo WiFi pro 1200e 2018-12-27 14:06:38 +01:00
image ath79: Add support for Ubiquiti Nanostation M (XW) 2019-03-05 03:15:52 +01:00
nand treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
patches-4.14 kernel: bump 4.14 to 4.14.95 2019-01-24 10:10:45 +01:00
tiny treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
config-4.14 ath79: add support for D-Link DIR-859 A1 2018-12-30 20:08:13 +01:00
Makefile ath79: Remove source-only flag 2018-11-26 12:24:54 +01:00
modules.mk ath79: add new OF only target for QCA MIPS silicon 2018-05-07 08:06:51 +02:00