This patch takes precautions against the use of blocking packet-stream
operations like 'submit_packet'.
With the change of issue #4388, the ready-to-submit signals are no
longer implicitly handled. Hence, a call of submit_packet to a
saturated submit queue blocks infinitely.
Issue #4390
Remove '_expected_offset' check on round trip test from RX packet,
because allocators between RX/TX can have different allocation
strategies. Rely on 'pattern' check for RX packets only.
In loopback server alloc size must match actual packet size.
issue #4312
This patch changes the 'Allocator' interface to the use of 'Attempt'
return values instead of using exceptions for propagating errors.
To largely uphold compatibility with components using the original
exception-based interface - in particluar use cases where an 'Allocator'
is passed to the 'new' operator - the traditional 'alloc' is still
supported. But it existes merely as a wrapper around the new
'try_alloc'.
Issue #4324
This patch makes the test less dependent on the rate of state updates by
calculating the upgraded quota from the values found in the state report
instead of simply increasing the '_ram_quota' for each incoming report.
ROM clients have to request an initial update of dynamic ROMs explicitly
and should not depend on artificial signals from the ROM session on
signal-handler registration.
Issue #4274
Increased number of trace subjects since the test sporadically fails on
some platforms.
Also added a sanity check to print an error message in case we run into
the same issue again.
Fixesgenodelabs/genode#4261
If the trace subjects are not properly destructed when the TRACE client
disappears, enabled sources will be owned by a non-existing client.
In other words, when a TRACE client disappears all sources owned by the
client must be disabled.
genodelabs/genode#4247
test-trace always passed, although tracing was never enabled because the
trace subject was not within the first 32 subjects.
* increase number of queried subjects
* output error if trace subject was not found
genodelabs/genode#4247
With this commit, the NIC router DHCP client reads out the first DNS domain
name (DHCP option 15) if any from a DHCP reply that generates an IPv4 config
for a domain and stores the name together with the IPv4 config for that domain.
DNS domain names are reported via the new report tag '<dns-domain>' if the
'config' attribute in the config tag '<report>' is set.
Furthermore, the NIC router DHCP server becomes able to obtain a DNS domain
name from another domain that has a DHCP client dynamically (given the config
attribute 'dns_config_from' is set and no static DNS config is given) or
statically from its configuration (new config tag '<dns-domain>') and propagate
this name with DHCP replies (DHCP option 15).
The 'nic_router_dhcp_*' tests are adapted to test the new feautures.
The commit also gets rid of some mirrored files in
'test/nic_router_dhcp/manager'.
Fixes#4246
WARNING: BREAKS CONFIG COMPATIBILITY!
This commit changes the configuration interface of the NIC router in a way that
may break systems that use the component without proper adjustment!
How to adjust:
At each occurrence of the 'dns_server_from' attribute in a NIC router
configuration replace the attribute name with 'dns_config_from'. The attribute
value remains unaltered.
DETAILED DESCRIPTION
The new attribute name 'dns_config_from' reflects that also other aspects of
the DNS configuration of the denominated domain are used by the DHCP server
that holds the attribute. This commit is a preparation for forwarding also the
domain name (DHCP option 15) with the mechanism behind the attribute.
Ref #4246
The NIC router DHCP server used to add an extra option 6 field to DHCP replies
for each DNS server address. This conflicts with RFC #2132 section 3.8 which
states that the addresses should be listed within one option 6 field without
delimiter. The discrepancy is fixed by this commit.
Ref #4242
BREAKS CONFIG COMPATIBILITY:
This commit changes the configuration interface of the NIC router in a way that
may break systems that use the component without proper adjustment!
HOW TO ADJUST:
At each occurrence of the '<uplink ...>' tag in a NIC router configuration
replace the tag name 'uplink' with 'nic-client'. The rest of the tag stays the
same.
The term "uplink" for network interfaces in the router that have a NIC session
client as back end was introduced in a time when Uplink sessions didn't yet
exist. Now, they do and, although both an uplink and an Uplink session
normally describe a network session between router and network device driver,
they are based on two different service types (NIC and Uplink). This can easily
cause confusion when integrating the router (the <uplink> is not related to
Uplink sessions) or trying to understand its functioning (an 'Uplink' object
has nothing to do with the Uplink service).
Therefore, this commit introduces the more specific term "NIC client" for an
interface that is based on a NIC session requested by the router. This doesn't
imply any semantic changes at the NIC router. However, the commit also brings a
broader update of the router's README and removes the term "downlink" that was
used only in documentation to refer to interfaces backed by a NIC session
provided by the router. The term was only associated with this meaning because
it is the natural counterpart to an uplink. This isn't appropriate anymore as
the terms for interface types have moved to a more technical level.
The commit adjusts all scenarios in the basic Genode repositories properly.
Fixes#4238
Enable watching files via the inotify interface of the Linux Kernel.
Delivery of watches to components is staggered in order to prevent an
overflow of the ACK queue in cases when a lot of changes are made to the
file system from the Linux side.
Fixes#4070
This patch adds the missing destruction of session-state objects of
local services when closing a session. Because of the missing
destruction, those session-state object remained part of the server
ID space. This becomes a problem once the backing store of the session
state object vanishes, that is when the client child gets removed from
the sandbox. Hence, the removal of a child with an open session to a
local service would lead to the corruption of the server ID space.
This patch adds the missing session.destroy() call.
Fixes#4044
* Remove SPEC declarations from mk/spec
* Remove all board-specific REQUIRE declaratiions left
* Replace [have_spec <board>] run-script declarations with have_board where necessary
* Remove addition of BOARD variable to SPECS in toplevel Makefile
* Move board-specific directories in base-hw out of specs
- depending on available PCI power cap power off and on
- save and restore PCI bars if required
- reset PCI devices after power on if supported
Fixes#3963
This commit restores the diag feature for selecting diagnostic output of
services provided by core. This feature became unavailable with commit
"base: remove dependency from deprecated APIs", which hard-wired the
diag flag for core services to false.
To control this feature, three possible policies can be expressed in a
routing target of init's configuration:
* Forcing silence by specifying 'diag="no"'
* Enabling diagnostics by specifying 'diag="yes"'
* Forwarding the preference of the client by omitting the 'diag'
attribute
Fixes#3962
* The NIC router now considers, memorizes, and, if configured, reports
multiple DHCP option 6 entries from DHCP replies that it received as DHCP
client
* A DHCP server at the NIC router can now be configured statically with
multiple DNS server addresses to propagate
* The 'dns_server_from' attribute of the DHCP server of the NIC router now
supports the forwarding of multiple DNS server addresses
* The automated run/nic_router_dhcp test tests all the above mentioned new
functionality and reconfiguring it at runtime. The test was added to the
autopilot.
* All run scripts were adapted to fit the new NIC router configuration
interface
Fixes#3952
* get rid of alarm abstraction
* get rid of Timeout::Time type
* get rid of pointer arguments
* get rid of _discard_timeout indirection
* get rid of 65th bit in stored time values
* get rid of Timeout_scheduler interface
* get rid of uninitialized deadlines
* get rid of default arguments
* get rid of Timeout::_periodic
* get rid of Timeout::Raw
* use list abstraction
* only one interface for timeout handlers
* rework locking scheme to be smp safe
* move all method definitions to CC file
* name mutexes more accurate
* fix when & how to set time-source timeout
* fix deadlocks
Fixes#3884
The combination of Net::Mac_address and
Genode::ascii_to(Net::Mac_address) required shaky quirks in several
places because GCC is not able to resolve the ascii_to overload if
base/xml_node.h was included to early. The current solution moves the
several ascii_to overloads "closer" to the Net types by putting them
into the Net namespace, where GCC reliably picks them up.
Hence, co-locating the ascii_to() utility with the overload type in the
same scope/namespace is good practice.
This patch removes the now obsolete <nic/xml_node.h> header file.
This commit applies the transition from the "Input" session to the "Event"
session to the event-filtering mechansim. The functionality of the
input_filter is now provided by the event_filter. The event filter
requests only one "Event" session as destination for the filter result,
which is usually routed to the nitpicker GUI server. It provides an
"Event" service to which any number of event sources can connect.
The configuration of the filter chain remains almost the same. Only the
declaration of the <input> nodes is no longer needed. Instead, the
configuration must specify <policy> nodes, which define the mapping of
"Event" clients (event sources) to the inputs used in the filter chain.
The patch adjusts all uses of the nitpicker GUI server accordingly such
that the event filter reports events to nitpicker's event service
instead of having nitpicker request an "Input" session. This dissolves
the dependency of nitpicker from input drivers.
Issue #3827
This patch replaces the use of the "Framebuffer" session interface by
the new "Capture" session interface in all framebuffer drivers. Thanks
to this change, those drivers have become mere clients of the nitpicker
GUI server now, and are no longer critical for the liveliness of the GUI
server.
The patch touches the following areas:
- The actual driver components. The new versions of all drivers have
been tested on the respective hardware. Generally, the drivers
have become simpler.
- The drivers_interactive packages for various boards. The drivers
subsystem no longer provides a "Framebuffer" service but needs a
valid route to the "Capture" service provided by nitpicker.
- The driver manager of Sculpt OS.
- This patch changes the role of the test-framebuffer component from a
framebuffer client to a capture server so that drivers (capture clients)
can be directly connected to the test component without the nitpicker
server.
- Framebuffer driver no longer support the unbuffered mode.
- The fb_bench.run script is no longer very meaningful because it
interplays solely with nitpicker, not with the driver directly.
- All run scripts for graphical scenarios and the related depot
archives got adapted to the change.
Fixes#3813
* Differentiate in between different architectures with assembler routines
for correct measures
* Automate first step measuring of 10G bogomips across different hardware
Fix#3785
Until now, Genode's framebuffer session interface was based on the
RGB565 pixel format. This patch changes the pixel format to 32-bit
XRGB where the X part is ignored. It adapts all graphical applications
and device drivers accordingly.
The patch also adjusts the users of the drivers_interactive packages,
assigning 64 MiB RAM and 1500 caps to the drivers subsystem, which is
sufficient for covering high resolutions at 32 bits per pixel and to
accommodate multi-component USB HID input stacks.
Fixes#3784
- Since Genode::strncpy is not 100% compatible with the POSIX
strncpy function, better use a distinct name.
- Remove bogus return value from the function, easing the potential
enforcement of mandatory return-value checks later.
Fixes#3752
This patch removes old 'Allocator_guard' utility and replaces its use
with the modern 'Constrained_ram_allocator'.
The adjustment of core in this respect has the side effect of a more
accurate capability accounting in core's CPU, TRACE, and RM services.
In particular, the dataspace capabilities needed for core-internal
allocations via the 'Sliced_heap' are accounted to the client now.
The same goes for nitpicker and nic_dump as other former users of the
allocator guard. Hence, the patch also touches code at the client and
server sides related to these services.
The only remaining user of the 'Allocator_guard' is the Intel GPU
driver. As the adaptation of this component would be too invasive
without testing, this patch leaves this component unchanged by keeping a
copy of the 'allocator_guard.h' locally at the component.
Fixes#3750
