openwrt/target/linux/realtek/rtl838x/config-5.10
Jan Hoffmann f2f09bc002 realtek: add support for HPE 1920 series
Hardware information:
---------------------

- HPE 1920-8G:
  - RTL8380 SoC
  - 8 Gigabit RJ45 ports (built-in RTL8218B)
  - 2 SFP ports (built-in SerDes)

- HPE 1920-16G / HPE 1920-24G (same board):
  - RTL8382 SoC
  - 16/24 Gigabit RJ45 ports (built-in RTL8218B, 1/2 external RTL8218D)
  - 4 SFP ports (external RTL8214FC)

- Common:
  - RJ45 RS232 port on front panel
  - 32 MiB NOR Flash
  - 128 MiB DDR3 DRAM
  - PT7A7514 watchdog

Booting initramfs image:
------------------------

- Prepare a FTP or TFTP server serving the OpenWrt initramfs image and
  connect the server to a switch port.

- Connect to the console port of the device and enter the extended
  boot menu by typing Ctrl+B when prompted.

- Choose the menu option "<3> Enter Ethernet SubMenu".

- Set network parameters via the option "<5> Modify Ethernet Parameter".
  Enter the FTP/TFTP filename as "Load File Name" ("Target File Name"
  can be left blank, it is not required for booting from RAM). Note that
  the configuration is saved on flash, so it only needs to be done once.

- Select "<1> Download Application Program To SDRAM And Run".

Initial installation:
---------------------

- Boot an initramfs image as described above, then use sysupgrade to
  install OpenWrt permanently. After initial installation, the
  bootloader needs to be configured to load the correct image file

- Enter the extended boot menu again and choose "<4> File Control",
  then select "<2> Set Application File type".

- Enter the number of the file "openwrt-kernel.bin" (should be 1), and
  use the option "<1> +Main" to select it as boot image.

- Choose "<0> Exit To Main Menu" and then "<1> Boot System".

NOTE: The bootloader on these devices can only boot from the VFS
filesystem which normally spans most of the flash. With OpenWrt, only
the first part of the firmware partition contains a valid filesystem,
the rest is used for rootfs. As the bootloader does not know about this,
you must not do any file operations in the bootloader, as this may
corrupt the OpenWrt installation (selecting the boot image is an
exception, as it only stores a flag in the bootloader data, but doesn't
write to the filesystem).

Signed-off-by: Jan Hoffmann <jan@3e8.eu>
2022-07-28 14:08:56 +02:00

209 lines
5.2 KiB
Plaintext

CONFIG_ARCH_32BIT_OFF_T=y
CONFIG_ARCH_HIBERNATION_POSSIBLE=y
CONFIG_ARCH_MMAP_RND_BITS_MAX=15
CONFIG_ARCH_MMAP_RND_COMPAT_BITS_MAX=15
CONFIG_ARCH_SUSPEND_POSSIBLE=y
CONFIG_BLK_DEV_RAM=y
CONFIG_BLK_DEV_RAM_COUNT=16
CONFIG_BLK_DEV_RAM_SIZE=4096
CONFIG_CEVT_R4K=y
CONFIG_CEVT_RTL9300=y
CONFIG_CLKDEV_LOOKUP=y
CONFIG_CLKSRC_MMIO=y
CONFIG_CLONE_BACKWARDS=y
CONFIG_COMMON_CLK=y
CONFIG_COMMON_CLK_BOSTON=y
CONFIG_COMPAT_32BIT_TIME=y
CONFIG_CONSOLE_LOGLEVEL_DEFAULT=15
CONFIG_CPU_BIG_ENDIAN=y
CONFIG_CPU_GENERIC_DUMP_TLB=y
CONFIG_CPU_HAS_DIEI=y
CONFIG_CPU_HAS_PREFETCH=y
CONFIG_CPU_HAS_RIXI=y
CONFIG_CPU_HAS_SYNC=y
CONFIG_CPU_MIPS32=y
# CONFIG_CPU_MIPS32_R1 is not set
CONFIG_CPU_MIPS32_R2=y
CONFIG_CPU_MIPSR2=y
CONFIG_CPU_NEEDS_NO_SMARTMIPS_OR_MICROMIPS=y
CONFIG_CPU_R4K_CACHE_TLB=y
CONFIG_CPU_SUPPORTS_32BIT_KERNEL=y
CONFIG_CPU_SUPPORTS_HIGHMEM=y
CONFIG_CPU_SUPPORTS_MSA=y
CONFIG_CRYPTO_BLAKE2S=y
CONFIG_CRYPTO_LIB_BLAKE2S_GENERIC=y
CONFIG_CRYPTO_LIB_POLY1305_RSIZE=2
CONFIG_CRYPTO_RNG2=y
CONFIG_CSRC_R4K=y
CONFIG_DEBUG_SECTION_MISMATCH=y
CONFIG_DMA_NONCOHERENT=y
CONFIG_DTC=y
CONFIG_EARLY_PRINTK=y
CONFIG_EARLY_PRINTK_8250=y
CONFIG_EXTRA_FIRMWARE="rtl838x_phy/rtl838x_8214fc.fw rtl838x_phy/rtl838x_8218b.fw rtl838x_phy/rtl838x_8380.fw"
CONFIG_EXTRA_FIRMWARE_DIR="firmware"
CONFIG_FIXED_PHY=y
CONFIG_FORCE_MAX_ZONEORDER=13
CONFIG_FW_LOADER_PAGED_BUF=y
CONFIG_GENERIC_ATOMIC64=y
CONFIG_GENERIC_CLOCKEVENTS=y
CONFIG_GENERIC_CMOS_UPDATE=y
CONFIG_GENERIC_CPU_AUTOPROBE=y
CONFIG_GENERIC_GETTIMEOFDAY=y
CONFIG_GENERIC_IOMAP=y
CONFIG_GENERIC_IRQ_CHIP=y
CONFIG_GENERIC_IRQ_EFFECTIVE_AFF_MASK=y
CONFIG_GENERIC_IRQ_SHOW=y
CONFIG_GENERIC_LIB_ASHLDI3=y
CONFIG_GENERIC_LIB_ASHRDI3=y
CONFIG_GENERIC_LIB_CMPDI2=y
CONFIG_GENERIC_LIB_LSHRDI3=y
CONFIG_GENERIC_LIB_UCMPDI2=y
CONFIG_GENERIC_PCI_IOMAP=y
CONFIG_GENERIC_PHY=y
CONFIG_GENERIC_PINCONF=y
CONFIG_GENERIC_PINCTRL_GROUPS=y
CONFIG_GENERIC_PINMUX_FUNCTIONS=y
CONFIG_GENERIC_SCHED_CLOCK=y
CONFIG_GENERIC_SMP_IDLE_THREAD=y
CONFIG_GENERIC_TIME_VSYSCALL=y
CONFIG_GPIOLIB=y
CONFIG_GPIOLIB_IRQCHIP=y
CONFIG_GPIO_GENERIC=y
CONFIG_GPIO_PCA953X=y
CONFIG_GPIO_PCA953X_IRQ=y
CONFIG_GPIO_REALTEK_OTTO=y
CONFIG_GPIO_RTL8231=y
CONFIG_GPIO_WATCHDOG=y
# CONFIG_GPIO_WATCHDOG_ARCH_INITCALL is not set
CONFIG_GRO_CELLS=y
CONFIG_HANDLE_DOMAIN_IRQ=y
CONFIG_HARDWARE_WATCHPOINTS=y
CONFIG_HAS_DMA=y
CONFIG_HAS_IOMEM=y
CONFIG_HAS_IOPORT_MAP=y
CONFIG_HIGH_RES_TIMERS=y
CONFIG_HWMON=y
CONFIG_HZ_PERIODIC=y
CONFIG_I2C=y
CONFIG_I2C_ALGOBIT=y
CONFIG_I2C_BOARDINFO=y
CONFIG_I2C_CHARDEV=y
CONFIG_I2C_GPIO=y
CONFIG_I2C_MUX=y
# CONFIG_I2C_RTL9300 is not set
# CONFIG_I2C_MUX_RTL9300 is not set
CONFIG_INITRAMFS_SOURCE=""
CONFIG_IRQCHIP=y
CONFIG_IRQ_DOMAIN=y
CONFIG_IRQ_FORCED_THREADING=y
CONFIG_IRQ_MIPS_CPU=y
CONFIG_IRQ_WORK=y
CONFIG_JFFS2_ZLIB=y
CONFIG_LEDS_GPIO=y
CONFIG_LEGACY_PTYS=y
CONFIG_LEGACY_PTY_COUNT=256
CONFIG_LIBFDT=y
CONFIG_LOCK_DEBUGGING_SUPPORT=y
CONFIG_MARVELL_PHY=y
CONFIG_MDIO_BUS=y
CONFIG_MDIO_DEVICE=y
CONFIG_MDIO_DEVRES=y
CONFIG_MDIO_I2C=y
CONFIG_MEMFD_CREATE=y
CONFIG_MFD_SYSCON=y
CONFIG_MIGRATION=y
CONFIG_MIPS=y
CONFIG_MIPS_ASID_BITS=8
CONFIG_MIPS_ASID_SHIFT=0
CONFIG_MIPS_CBPF_JIT=y
CONFIG_MIPS_CLOCK_VSYSCALL=y
# CONFIG_MIPS_CMDLINE_DTB_EXTEND is not set
# CONFIG_MIPS_CMDLINE_FROM_BOOTLOADER is not set
CONFIG_MIPS_CMDLINE_FROM_DTB=y
# CONFIG_MIPS_ELF_APPENDED_DTB is not set
CONFIG_MIPS_L1_CACHE_SHIFT=5
CONFIG_MIPS_LD_CAN_LINK_VDSO=y
# CONFIG_MIPS_NO_APPENDED_DTB is not set
CONFIG_MIPS_RAW_APPENDED_DTB=y
CONFIG_MIPS_SPRAM=y
CONFIG_MODULES_USE_ELF_REL=y
CONFIG_MTD_CFI_ADV_OPTIONS=y
CONFIG_MTD_CFI_GEOMETRY=y
CONFIG_MTD_CMDLINE_PARTS=y
CONFIG_MTD_JEDECPROBE=y
CONFIG_MTD_SPI_NOR=y
CONFIG_MTD_SPLIT_BRNIMAGE_FW=y
CONFIG_MTD_SPLIT_EVA_FW=y
CONFIG_MTD_SPLIT_FIRMWARE=y
CONFIG_MTD_SPLIT_H3C_VFS=y
CONFIG_MTD_SPLIT_TPLINK_FW=y
CONFIG_MTD_SPLIT_UIMAGE_FW=y
CONFIG_NEED_DMA_MAP_STATE=y
CONFIG_NEED_PER_CPU_KM=y
CONFIG_NET_DEVLINK=y
CONFIG_NET_DSA=y
CONFIG_NET_DSA_RTL83XX=y
CONFIG_NET_DSA_TAG_TRAILER=y
CONFIG_NET_RTL838X=y
CONFIG_NET_SWITCHDEV=y
CONFIG_NO_GENERIC_PCI_IOPORT_MAP=y
CONFIG_NVMEM=y
CONFIG_OF=y
CONFIG_OF_ADDRESS=y
CONFIG_OF_EARLY_FLATTREE=y
CONFIG_OF_FLATTREE=y
CONFIG_OF_GPIO=y
CONFIG_OF_IRQ=y
CONFIG_OF_KOBJ=y
CONFIG_OF_MDIO=y
CONFIG_OF_NET=y
CONFIG_PCI_DRIVERS_LEGACY=y
CONFIG_PERF_USE_VMALLOC=y
CONFIG_PGTABLE_LEVELS=2
CONFIG_PHYLIB=y
CONFIG_PHYLINK=y
CONFIG_PINCTRL=y
CONFIG_POWER_RESET=y
CONFIG_POWER_RESET_GPIO_RESTART=y
CONFIG_POWER_RESET_SYSCON=y
CONFIG_RATIONAL=y
CONFIG_REALTEK_OTTO_WDT=y
CONFIG_REALTEK_PHY=y
CONFIG_REALTEK_SOC_PHY=y
CONFIG_REGMAP=y
CONFIG_REGMAP_I2C=y
CONFIG_REGMAP_MMIO=y
CONFIG_RESET_CONTROLLER=y
CONFIG_RTL83XX=y
CONFIG_RTL838X=y
# CONFIG_RTL839X is not set
# CONFIG_RTL930X is not set
# CONFIG_RTL931X is not set
CONFIG_SERIAL_MCTRL_GPIO=y
CONFIG_SERIAL_OF_PLATFORM=y
CONFIG_SFP=y
CONFIG_SPI=y
CONFIG_SPI_MASTER=y
CONFIG_SPI_MEM=y
CONFIG_SRCU=y
CONFIG_SWPHY=y
CONFIG_SYSCTL_EXCEPTION_TRACE=y
CONFIG_SYS_HAS_CPU_MIPS32_R1=y
CONFIG_SYS_HAS_CPU_MIPS32_R2=y
CONFIG_SYS_HAS_EARLY_PRINTK=y
CONFIG_SYS_SUPPORTS_32BIT_KERNEL=y
CONFIG_SYS_SUPPORTS_ARBIT_HZ=y
CONFIG_SYS_SUPPORTS_BIG_ENDIAN=y
CONFIG_SYS_SUPPORTS_MIPS16=y
CONFIG_TARGET_ISA_REV=2
CONFIG_TICK_CPU_ACCOUNTING=y
CONFIG_TIMER_OF=y
CONFIG_TIMER_PROBE=y
CONFIG_TINY_SRCU=y
CONFIG_USE_GENERIC_EARLY_PRINTK_8250=y
CONFIG_USE_OF=y
CONFIG_WATCHDOG_CORE=y
CONFIG_ZLIB_DEFLATE=y
CONFIG_ZLIB_INFLATE=y