mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-25 00:11:13 +00:00
9e78db0229
Hardware * Mediatek MT7620A + Mediatek MT7610EN * 64MB RAM * 8MB NAND (Winbond 25064FVSIG ) Both 2.4GHZ and 5GHZ are working, it is enabled by default since there is no physical ethernet port in the device. All LED's and buttons work. UART: 57600 8N1 3.3V Installation Upload the openwrt-ramips-mt7620-trendnet_tha103ac-initramfs-kernel.bin via the manufacturer firmware upgrade page on the device. Upon reboot wait +- 3 mins until the green power LED is not flashing anymore (do not be tempted to switch the device off while the LED is flashing, unless you are ready for soldering and TTL) and then press the WPS button to enable the default OpenWrt Wifi AP, the BLUE wifi LED will start flash. Then install openwrt-ramips-mt7620-trendnet_tha103ac-squashfs-sysupgrade.bin via OpenWrt. The integrated power monitoring and relay do not work in OpenWrt as the PL7223 chip source/documentation is unavailable. Recovery Mis-configuration can be dealt with using the RESET button to reset to factory, worst case scenario will require some serious work and soldering, there's pads on the PCB for both the UART and ETH0, and I soldered and tested that it does work. You will have to power the board using the header pins GND & 5V, see the 8-pin header socket. Signed-off-by: Die Peter Pan <diepeterpan@gmail.com> Link: https://github.com/openwrt/openwrt/pull/17114 Signed-off-by: John Crispin <john@phrozen.org> |
||
|---|---|---|
| .. | ||
| base-files | ||
| config-6.6 | ||
| target.mk | ||