mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-18 13:26:34 +00:00
ramips: mt7620: add support for THA-103AC (Version v1.0R)
Hardware * Mediatek MT7620A + Mediatek MT7610EN * 64MB RAM * 8MB NAND (Winbond 25064FVSIG ) Both 2.4GHZ and 5GHZ are working, it is enabled by default since there is no physical ethernet port in the device. All LED's and buttons work. UART: 57600 8N1 3.3V Installation Upload the openwrt-ramips-mt7620-trendnet_tha103ac-initramfs-kernel.bin via the manufacturer firmware upgrade page on the device. Upon reboot wait +- 3 mins until the green power LED is not flashing anymore (do not be tempted to switch the device off while the LED is flashing, unless you are ready for soldering and TTL) and then press the WPS button to enable the default OpenWrt Wifi AP, the BLUE wifi LED will start flash. Then install openwrt-ramips-mt7620-trendnet_tha103ac-squashfs-sysupgrade.bin via OpenWrt. The integrated power monitoring and relay do not work in OpenWrt as the PL7223 chip source/documentation is unavailable. Recovery Mis-configuration can be dealt with using the RESET button to reset to factory, worst case scenario will require some serious work and soldering, there's pads on the PCB for both the UART and ETH0, and I soldered and tested that it does work. You will have to power the board using the header pins GND & 5V, see the 8-pin header socket. Signed-off-by: Die Peter Pan <diepeterpan@gmail.com> Link: https://github.com/openwrt/openwrt/pull/17114 Signed-off-by: John Crispin <john@phrozen.org>
This commit is contained in:
Die Peter Pan
John Crispin
parent
c90842b0d1
commit
9e78db0229
201
target/linux/ramips/dts/mt7620a_trendnet_tha103ac.dts
Normal file
201
target/linux/ramips/dts/mt7620a_trendnet_tha103ac.dts
Normal file
@ -0,0 +1,201 @@
|
||||
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
||||
|
||||
#include "mt7620a.dtsi"
|
||||
|
||||
#include <dt-bindings/gpio/gpio.h>
|
||||
#include <dt-bindings/input/input.h>
|
||||
#include <dt-bindings/leds/common.h>
|
||||
|
||||
/ {
|
||||
compatible = "trendnet,tha103ac", "ralink,mt7620a-soc";
|
||||
model = "TRENDNET THA-103AC (EU)";
|
||||
|
||||
aliases {
|
||||
label-mac-device = ðernet;
|
||||
led-boot = &led_power;
|
||||
led-failsafe = &led_power;
|
||||
led-running = &led_power;
|
||||
led-upgrade = &led_power;
|
||||
};
|
||||
|
||||
keys: keys {
|
||||
compatible = "gpio-keys";
|
||||
|
||||
button_reset {
|
||||
label = "reset";
|
||||
gpios = <&gpio0 9 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_RESTART>;
|
||||
};
|
||||
|
||||
/* wps button reassigned to rfkill */
|
||||
button_rfkill {
|
||||
label = "wifi on/off";
|
||||
gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_RFKILL>;
|
||||
};
|
||||
|
||||
};
|
||||
|
||||
leds {
|
||||
compatible = "gpio-leds";
|
||||
|
||||
led-0 {
|
||||
color = <LED_COLOR_ID_GREEN>;
|
||||
function = LED_FUNCTION_WPS;
|
||||
gpios = <&gpio0 10 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
led_power: led-1 {
|
||||
color = <LED_COLOR_ID_GREEN>;
|
||||
function = LED_FUNCTION_POWER;
|
||||
gpios = <&gpio0 14 GPIO_ACTIVE_LOW>;
|
||||
default-state = "on";
|
||||
};
|
||||
|
||||
led-2 {
|
||||
color = <LED_COLOR_ID_BLUE>;
|
||||
function = LED_FUNCTION_WLAN;
|
||||
gpios = <&gpio1 14 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
led-3 {
|
||||
color = <LED_COLOR_ID_BLUE>;
|
||||
/* LED_FUNCTION_RSSILOW isn't implemented yet */
|
||||
function = "rssilow";
|
||||
gpios = <&gpio2 16 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
led-4 {
|
||||
color = <LED_COLOR_ID_BLUE>;
|
||||
/* LED_FUNCTION_RSSIMEDLOW isn't implemented yet */
|
||||
function = "rssimedlow";
|
||||
gpios = <&gpio2 17 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
led-5 {
|
||||
color = <LED_COLOR_ID_BLUE>;
|
||||
/* LED_FUNCTION_RSSIMEDIUM isn't implemented yet */
|
||||
function = "rssimedium";
|
||||
gpios = <&gpio2 18 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
led-6 {
|
||||
color = <LED_COLOR_ID_BLUE>;
|
||||
/* LED_FUNCTION_RSSIHIGH isn't implemented yet */
|
||||
function = "rssihigh";
|
||||
gpios = <&gpio2 19 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&spi0 {
|
||||
status = "okay";
|
||||
|
||||
flash@0 {
|
||||
compatible = "jedec,spi-nor";
|
||||
reg = <0>;
|
||||
spi-max-frequency = <50000000>;
|
||||
|
||||
partitions {
|
||||
compatible = "fixed-partitions";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
partition@0 {
|
||||
label = "u-boot";
|
||||
reg = <0x0 0x30000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@30000 {
|
||||
label = "u-boot-env";
|
||||
reg = <0x30000 0x10000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@40000 {
|
||||
label = "factory";
|
||||
reg = <0x40000 0x10000>;
|
||||
read-only;
|
||||
|
||||
nvmem-layout {
|
||||
compatible = "fixed-layout";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
eeprom_factory_0: eeprom@0 {
|
||||
reg = <0x0 0x200>;
|
||||
};
|
||||
|
||||
eeprom_factory_8000: eeprom@8000 {
|
||||
reg = <0x8000 0x200>;
|
||||
};
|
||||
|
||||
macaddr_factory_4: macaddr@4 {
|
||||
compatible = "mac-base";
|
||||
reg = <0x4 0x6>;
|
||||
#nvmem-cell-cells = <1>;
|
||||
};
|
||||
|
||||
macaddr_factory_28: macaddr@28 {
|
||||
compatible = "mac-base";
|
||||
reg = <0x28 0x6>;
|
||||
#nvmem-cell-cells = <1>;
|
||||
};
|
||||
|
||||
macaddr_factory_8004: macaddr@8004 {
|
||||
compatible = "mac-base";
|
||||
reg = <0x8004 0x6>;
|
||||
#nvmem-cell-cells = <1>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
partition@50000 {
|
||||
compatible = "denx,uimage";
|
||||
label = "firmware";
|
||||
reg = <0x50000 0x7b0000>;
|
||||
};
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&state_default {
|
||||
gpio {
|
||||
groups = "i2c", "uartf", "ephy";
|
||||
function = "gpio";
|
||||
};
|
||||
};
|
||||
|
||||
ðernet {
|
||||
nvmem-cells = <&macaddr_factory_28 0>;
|
||||
nvmem-cell-names = "mac-address";
|
||||
|
||||
mediatek,portmap = "wl";
|
||||
};
|
||||
|
||||
&gpio1 {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&gpio2 {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&wmac {
|
||||
nvmem-cells = <&eeprom_factory_0>, <&macaddr_factory_4 0>;
|
||||
nvmem-cell-names = "eeprom", "mac-address";
|
||||
};
|
||||
|
||||
&pcie {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&pcie0 {
|
||||
wifi@0,0 {
|
||||
reg = <0x0000 0 0 0 0>;
|
||||
ieee80211-freq-limit = <5000000 6000000>;
|
||||
nvmem-cells = <&eeprom_factory_8000>, <&macaddr_factory_8004 0>;
|
||||
nvmem-cell-names = "eeprom", "mac-address";
|
||||
};
|
||||
};
|
||||
@ -1322,6 +1322,16 @@ define Device/trendnet_tew-810dr
|
||||
endef
|
||||
TARGET_DEVICES += trendnet_tew-810dr
|
||||
|
||||
define Device/trendnet_tha103ac
|
||||
SOC := mt7620a
|
||||
DEVICE_PACKAGES := kmod-mt76x0e rssileds
|
||||
DEVICE_VENDOR := TRENDnet
|
||||
DEVICE_MODEL := THA-103AC
|
||||
IMAGE_SIZE := 7872k
|
||||
SUPPORTED_DEVICES += mt7620a_mt7610e
|
||||
endef
|
||||
TARGET_DEVICES += trendnet_tha103ac
|
||||
|
||||
define Device/vonets_var11n-300
|
||||
SOC := mt7620n
|
||||
IMAGE_SIZE := 3776k
|
||||
|
||||
@ -249,6 +249,13 @@ tplink,ec220-g5-v2)
|
||||
tplink,re200-v1)
|
||||
ucidef_set_led_netdev "lan" "lan" "green:lan" "eth0"
|
||||
;;
|
||||
trendnet,tha103ac)
|
||||
ucidef_set_rssimon "wlan0" "200000" "1"
|
||||
ucidef_set_led_rssi "led_rssilow" "RSSILOW" "blue:rssilow" "wlan0" "31" "100"
|
||||
ucidef_set_led_rssi "led_rssimedlow" "RSSIMEDIUMLOW" "blue:rssimedlow" "wlan0" "41" "100"
|
||||
ucidef_set_led_rssi "led_rssimedium" "RSSIMEDIUM" "blue:rssimedium" "wlan0" "51" "100"
|
||||
ucidef_set_led_rssi "led_rssihigh" "RSSIHIGH" "blue:rssihigh" "wlan0" "71" "100"
|
||||
;;
|
||||
wavlink,wl-wn535k1)
|
||||
ucidef_set_led_switch "lan1" "lan1" "green:lan1" "switch0" "0x20"
|
||||
ucidef_set_led_switch "lan2" "lan2" "green:lan2" "switch0" "0x04"
|
||||
|
||||
@ -65,6 +65,7 @@ ramips_setup_interfaces()
|
||||
sercomm,na930|\
|
||||
tplink,re200-v1|\
|
||||
tplink,re210-v1|\
|
||||
trendnet,tha103ac|\
|
||||
yukai,bocco|\
|
||||
zbtlink,zbt-cpe102|\
|
||||
zte,q7)
|
||||
@ -340,7 +341,8 @@ ramips_setup_macs()
|
||||
asus,rt-ac54u)
|
||||
lan_mac=$(mtd_get_mac_binary factory 0x22)
|
||||
;;
|
||||
dlink,dch-m225)
|
||||
dlink,dch-m225|\
|
||||
trendnet,tha103ac)
|
||||
lan_mac=$(mtd_get_mac_ascii factory lanmac)
|
||||
;;
|
||||
dlink,dir-510l|\
|
||||
|
||||
Loading…
Reference in New Issue
Block a user