openwrt/target/linux/lantiq/image
Thomas Nixon 50e3659703 lantiq: add Netgear DM200 support
Netgear DM200 is an inexpensive VDSL modem:

    CPU: VRX220 MIPS 34Kc 5.6 @ 500Mhz
    RAM: 64MiB
    Flash: 8MiB
    Ethernet: 1x100M
    DSL: VDSL2+, ADSL2+
    reset button, 3x bi-color LEDs

Serial port is 115200 baud, on the 4 pin header; pins from the bottom to
top are GND, RX, TX.

To upgrade from the vendor firmware, upload factory.img

The DM200 bootloader supports flashing over TFTP; hold the reset button
while powering on the device, and wait for the power light to start
flashing green before releasing. The device is now listening on
192.168.0.1/24, and can be sent a factory.img or a netgear image with a
TFTP put.

Once the image is loaded, it will be written to the flash, and the
device will reboot; this will take a few minutes.

Thanks to Edward O'Callaghan and Baptiste Jonglez, who implemented their
own ports for this device and provided valuable feedback.

Signed-off-by: Thomas Nixon <tom@tomn.co.uk>
2017-07-07 07:13:24 +02:00
..
eva.dummy.squashfs bump kernel to 3.2.12 2012-03-25 08:50:09 +00:00
Makefile lantiq: add Netgear DM200 support 2017-07-07 07:13:24 +02:00
tp-link.mk build: move mktplinkfw2 related commands to image-commands.mk 2017-06-29 10:37:36 +02:00
ubinize-overlay.cfg lantiq: ubinize autoresize flag for rootfs_data 2014-06-24 18:12:41 +00:00
ubinize.cfg lantiq: add a subtarget for the xrx200 SoC family 2013-09-17 21:46:00 +00:00