Lea Teuberth 45255aa0e8 ramips: adding support for Asus RP-AC56 ... Specifications: CPU: MT7621A dual-core 880MHz RAM: 64MB DDR2 FLASH: 16MB MX25L12805D NOR SPI WIFI: 2.4GHz 2x2 MT7603 b/g/n PCI WIFI: 5GHz 2x2 MT7662 a/b/ac PCI ETH: 1xLAN 1000base-T integrated SWITCH: MT7530 Port 0: LAN, Port 6: CPU LED: Power, 2.4GHz WiFi, 5GHz WiFi BTN: WPS, Reset UART: Near ETH port, from ETH: 3V3-TxD-GND-RxD 57600 8n1 MISC: Audio support Installation: 1. Update using recovery mode - while holdig "reset" button, power on the device - keep holding "reset" until power led is flashing yellow - set own IP to 192.168.1.75, subnet mask: 255.255.255.0 - push firmware image (can be factory.bin or sysupgrade.bin) using tftp client in binary mode to 192.168.1.1 Notes: This board has only two MAC addresses programmed in the "factory" partition: - MAC for wlan0 (2.4GHz) at offset 0x0004 - MAC for wlan1 (5GHz) at offset 0x8004 - stock firmware re-uses wlan0 MAC for ethernet - no valid addresses found in 0x28, 0x2e, 0xe000 and 0xe006 Signed-off-by: Lea Teuberth <lea.teuberth@outlook.com>		2022-08-06 19:58:46 +02:00
..
01_leds	ramips: add support for Netgear WAX202	2022-07-19 14:49:04 +02:00
02_network	ramips: adding support for Asus RP-AC56	2022-08-06 19:58:46 +02:00
03_gpio_switches	ramips: mt7621: Add support for ZyXEL NR7101	2021-05-09 09:15:44 +02:00
05_compat-version	treewide: remove execute bit and shebang from board.d files	2021-03-06 11:30:06 +01:00