mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-19 13:48:06 +00:00
ramips: adding support for Asus RP-AC56
Specifications: CPU: MT7621A dual-core 880MHz RAM: 64MB DDR2 FLASH: 16MB MX25L12805D NOR SPI WIFI: 2.4GHz 2x2 MT7603 b/g/n PCI WIFI: 5GHz 2x2 MT7662 a/b/ac PCI ETH: 1xLAN 1000base-T integrated SWITCH: MT7530 Port 0: LAN, Port 6: CPU LED: Power, 2.4GHz WiFi, 5GHz WiFi BTN: WPS, Reset UART: Near ETH port, from ETH: 3V3-TxD-GND-RxD 57600 8n1 MISC: Audio support Installation: 1. Update using recovery mode - while holdig "reset" button, power on the device - keep holding "reset" until power led is flashing yellow - set own IP to 192.168.1.75, subnet mask: 255.255.255.0 - push firmware image (can be factory.bin or sysupgrade.bin) using tftp client in binary mode to 192.168.1.1 Notes: This board has only two MAC addresses programmed in the "factory" partition: - MAC for wlan0 (2.4GHz) at offset 0x0004 - MAC for wlan1 (5GHz) at offset 0x8004 - stock firmware re-uses wlan0 MAC for ethernet - no valid addresses found in 0x28, 0x2e, 0xe000 and 0xe006 Signed-off-by: Lea Teuberth <lea.teuberth@outlook.com>
This commit is contained in:
Lea Teuberth
Hauke Mehrtens
parent
9edda3169f
commit
45255aa0e8
243
target/linux/ramips/dts/mt7621_asus_rp-ac56.dts
Normal file
243
target/linux/ramips/dts/mt7621_asus_rp-ac56.dts
Normal file
@ -0,0 +1,243 @@
|
||||
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
||||
|
||||
#include "mt7621.dtsi"
|
||||
|
||||
#include <dt-bindings/gpio/gpio.h>
|
||||
#include <dt-bindings/input/input.h>
|
||||
|
||||
/ {
|
||||
compatible = "asus,rp-ac56", "mediatek,mt7621-soc";
|
||||
model = "Asus RP-AC56";
|
||||
|
||||
aliases {
|
||||
led-boot = &led_power_orange;
|
||||
led-failsafe = &led_power_orange;
|
||||
led-running = &led_power_white;
|
||||
led-upgrade = &led_power_blue;
|
||||
label-mac-device = &gmac0;
|
||||
};
|
||||
|
||||
leds {
|
||||
compatible = "gpio-leds";
|
||||
|
||||
wlan2g_red {
|
||||
label = "red:wlan2g";
|
||||
gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
wlan2g_blue {
|
||||
label = "blue:wlan2g";
|
||||
gpios = <&gpio 12 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
wlan2g_green {
|
||||
label = "green:wlan2g";
|
||||
gpios = <&gpio 13 GPIO_ACTIVE_HIGH>;
|
||||
linux,default-trigger = "phy0tpt";
|
||||
};
|
||||
|
||||
wlan5g_red {
|
||||
label = "red:wlan5g";
|
||||
gpios = <&gpio 45 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
wlan5g_blue {
|
||||
label = "blue:wlan5g";
|
||||
gpios = <&gpio 43 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
wlan5g_green {
|
||||
label = "green:wlan5g";
|
||||
gpios = <&gpio 44 GPIO_ACTIVE_HIGH>;
|
||||
linux,default-trigger = "phy1tpt";
|
||||
};
|
||||
|
||||
led_power_white: power_white {
|
||||
label = "white:power";
|
||||
gpios = <&gpio 48 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
led_power_orange: power_orange {
|
||||
label = "orange:power";
|
||||
gpios = <&gpio 47 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
led_power_blue: power_blue {
|
||||
label = "blue:power";
|
||||
gpios = <&gpio 46 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
};
|
||||
|
||||
keys {
|
||||
compatible = "gpio-keys";
|
||||
|
||||
wps {
|
||||
label = "wps";
|
||||
gpios = <&gpio 10 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_WPS_BUTTON>;
|
||||
};
|
||||
|
||||
reset {
|
||||
label = "reset";
|
||||
gpios = <&gpio 41 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_RESTART>;
|
||||
};
|
||||
};
|
||||
|
||||
sound {
|
||||
compatible = "simple-audio-card";
|
||||
simple-audio-card,name = "Audio-I2S";
|
||||
simple-audio-card,format = "i2s";
|
||||
simple-audio-card,bitclock-master = <&dailink0_master>;
|
||||
simple-audio-card,frame-master = <&dailink0_master>;
|
||||
simple-audio-card,routing =
|
||||
"Headphone Jack", "HP_L",
|
||||
"Headphone Jack", "HP_R";
|
||||
simple-audio-card,mclk-fs = <256>;
|
||||
|
||||
simple-audio-card,cpu {
|
||||
sound-dai = <&i2s>;
|
||||
};
|
||||
|
||||
dailink0_master: simple-audio-card,codec {
|
||||
sound-dai = <&codec>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&gpio {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&spi0 {
|
||||
status = "okay";
|
||||
|
||||
flash@0 {
|
||||
compatible = "jedec,spi-nor";
|
||||
reg = <0>;
|
||||
spi-max-frequency = <50000000>;
|
||||
m25p,fast-read;
|
||||
|
||||
partitions {
|
||||
compatible = "fixed-partitions";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
partition@0 {
|
||||
label = "u-boot";
|
||||
reg = <0x0 0x30000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@30000 {
|
||||
label = "nvram";
|
||||
reg = <0x30000 0x10000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
factory: partition@40000 {
|
||||
label = "factory";
|
||||
reg = <0x40000 0x10000>;
|
||||
read-only;
|
||||
|
||||
compatible = "nvmem-cells";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
|
||||
macaddr_factory_4: macaddr@4 {
|
||||
reg = <0x4 0x6>;
|
||||
};
|
||||
};
|
||||
|
||||
partition@50000 {
|
||||
compatible = "denx,uimage";
|
||||
label = "firmware";
|
||||
reg = <0x50000 0xfa0000>;
|
||||
};
|
||||
|
||||
radio: partition@ff0000 {
|
||||
label = "radio";
|
||||
reg = <0xff0000 0x10000>;
|
||||
read-only;
|
||||
};
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&state_default {
|
||||
gpio {
|
||||
groups = "uart2";
|
||||
function = "gpio";
|
||||
};
|
||||
};
|
||||
|
||||
&pinctrl {
|
||||
i2s_pins: i2s {
|
||||
i2s {
|
||||
groups = "uart3";
|
||||
function = "i2s";
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&pcie {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&pcie0 {
|
||||
wifi@0,0 {
|
||||
compatible = "mediatek,mt76";
|
||||
reg = <0x0000 0 0 0 0>;
|
||||
mediatek,mtd-eeprom = <&factory 0x0000>;
|
||||
ieee80211-freq-limit = <2400000 2500000>;
|
||||
};
|
||||
};
|
||||
|
||||
&pcie1 {
|
||||
wifi@0,0 {
|
||||
compatible = "mediatek,mt76";
|
||||
reg = <0x0000 0 0 0 0>;
|
||||
mediatek,mtd-eeprom = <&factory 0x8000>;
|
||||
ieee80211-freq-limit = <5000000 6000000>;
|
||||
};
|
||||
};
|
||||
|
||||
&gmac0 {
|
||||
nvmem-cells = <&macaddr_factory_4>;
|
||||
nvmem-cell-names = "mac-address";
|
||||
};
|
||||
|
||||
&switch0 {
|
||||
ports {
|
||||
port@0 {
|
||||
status = "okay";
|
||||
label = "lan";
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&xhci {
|
||||
status = "disabled";
|
||||
};
|
||||
|
||||
&i2c {
|
||||
status = "okay";
|
||||
|
||||
codec: wm8960@18 {
|
||||
#sound-dai-cells = <0>;
|
||||
compatible = "wlf,wm8960";
|
||||
reg = <0x18>;
|
||||
wlf,shared-lrclk;
|
||||
};
|
||||
};
|
||||
|
||||
&gdma {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&i2s {
|
||||
#sound-dai-cells = <0>;
|
||||
status = "okay";
|
||||
pinctrl-names = "default";
|
||||
pinctrl-0 = <&i2s_pins>;
|
||||
};
|
||||
@ -189,6 +189,22 @@ define Device/asiarf_ap7621-nv1
|
||||
endef
|
||||
TARGET_DEVICES += asiarf_ap7621-nv1
|
||||
|
||||
define Device/asus_rp-ac56
|
||||
$(Device/dsa-migration)
|
||||
$(Device/uimage-lzma-loader)
|
||||
DEVICE_VENDOR := ASUS
|
||||
DEVICE_MODEL := RP-AC56
|
||||
IMAGE_SIZE := 16000k
|
||||
BLOCKSIZE := 64k
|
||||
DEVICE_PACKAGES := kmod-mt7603 kmod-mt76x2 \
|
||||
kmod-i2c-ralink kmod-sound-mt7620
|
||||
IMAGES += factory.bin
|
||||
IMAGE/factory.bin := append-kernel | append-rootfs | pad-rootfs | check-size
|
||||
IMAGE/sysupgrade.bin := append-kernel | append-rootfs | pad-rootfs | \
|
||||
check-size | append-metadata
|
||||
endef
|
||||
TARGET_DEVICES += asus_rp-ac56
|
||||
|
||||
define Device/asus_rp-ac87
|
||||
$(Device/dsa-migration)
|
||||
$(Device/uimage-lzma-loader)
|
||||
|
||||
@ -9,6 +9,7 @@ ramips_setup_interfaces()
|
||||
|
||||
case $board in
|
||||
ampedwireless,ally-00x19k|\
|
||||
asus,rp-ac56|\
|
||||
asus,rp-ac87|\
|
||||
edimax,re23s|\
|
||||
mikrotik,routerboard-m11g|\
|
||||
|
||||
Loading…
Reference in New Issue
Block a user