Tomasz Maciej Nowak 09448d8ff3 x86: add Roqos Core RC10 ethernet interfaces ... eth0 -> single NIC (i211at) eth1 -> single NIC (i211at) -> 4-port unmanaged switch (BCM53125U) Notes UART is exposed on J4 connector, pinout starting from pin marked 1: 1. GND, 2. NC?, 3. NC?, 4. RX, 5. TX, 6. NC? baud: 115200, parity: none, flow control: none The board is setup by coreboot with UEFI. To enter setup screen hold ESC key on boot. The 5-LED multicolor matrix is attached on first I2C device named "Synopsys DesignWare I2C adapter" at address 0x60. Controlling values are stored in /opt/roqos/etc/rcLED.conf of original firmware. Remember to backup the original firmware, there are no downloadable copies. Signed-off-by: Tomasz Maciej Nowak <tmn505@gmail.com>		2021-06-06 00:26:13 +02:00
..
01_leds	treewide: remove execute bit and shebang from board.d files	2021-03-06 11:30:06 +01:00
02_network	x86: add Roqos Core RC10 ethernet interfaces	2021-06-06 00:26:13 +02:00