Tomasz Maciej Nowak 09448d8ff3 x86: add Roqos Core RC10 ethernet interfaces ... eth0 -> single NIC (i211at) eth1 -> single NIC (i211at) -> 4-port unmanaged switch (BCM53125U) Notes UART is exposed on J4 connector, pinout starting from pin marked 1: 1. GND, 2. NC?, 3. NC?, 4. RX, 5. TX, 6. NC? baud: 115200, parity: none, flow control: none The board is setup by coreboot with UEFI. To enter setup screen hold ESC key on boot. The 5-LED multicolor matrix is attached on first I2C device named "Synopsys DesignWare I2C adapter" at address 0x60. Controlling values are stored in /opt/roqos/etc/rcLED.conf of original firmware. Remember to backup the original firmware, there are no downloadable copies. Signed-off-by: Tomasz Maciej Nowak <tmn505@gmail.com>		2021-06-06 00:26:13 +02:00
..
imagebuilder	imagebuilder: unset BINARY_FOLDER and DOWNLOAD_FOLDER in final archive	2021-05-08 12:14:00 +02:00
linux	x86: add Roqos Core RC10 ethernet interfaces	2021-06-06 00:26:13 +02:00
sdk	sdk: unset BINARY_FOLDER and DOWNLOAD_FOLDER in final archives	2021-05-08 12:14:04 +02:00
toolchain	target: fix copying of licenses for SDK/toolchain	2021-02-14 21:56:29 +01:00
Config.in	include/image*: add support for device-tree overlays	2021-03-17 17:45:34 +00:00
Makefile