openwrt/target/linux/ath79/dts/ar7161_dlink_dir-825-b1.dts

238 lines
3.8 KiB
Plaintext
Raw Normal View History

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "ar7100.dtsi"
/ {
compatible = "dlink,dir-825-b1", "qca,ar7161";
model = "D-Link DIR825B1";
aliases {
led-boot = &orange_power;
led-failsafe = &orange_power;
led-running = &blue_power;
led-upgrade = &orange_power;
};
extosc: ref {
compatible = "fixed-clock";
#clock-cells = <0>;
clock-output-names = "ref";
clock-frequency = <40000000>;
};
leds {
compatible = "gpio-leds";
blue_usb {
label = "d-link:blue:usb";
gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
trigger-sources = <&usb_ochi_port>, <&usb_echi_port>;
linux,default-trigger = "usbport";
};
orange_power: orange_power {
label = "d-link:orange:power";
gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
default-state = "on";
};
blue_power: blue_power {
label = "d-link:blue:power";
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
};
blue_wps {
label = "d-link:blue:wps";
gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
};
orange_planet {
label = "d-link:orange:planet";
gpios = <&gpio 6 GPIO_ACTIVE_LOW>;
};
blue_planet {
label = "d-link:blue:planet";
gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
};
};
ath9k-leds {
compatible = "gpio-leds";
wlan2g {
label = "d-link:blue:wlan2g";
gpios = <&ath9k0 5 GPIO_ACTIVE_LOW>;
linux,default-trigger = "phy0tpt";
};
wlan5g {
label = "d-link:blue:wlan5g";
gpios = <&ath9k1 5 GPIO_ACTIVE_LOW>;
linux,default-trigger = "phy1tpt";
};
};
keys {
compatible = "gpio-keys-polled";
poll-interval = <20>;
reset {
label = "reset";
linux,code = <KEY_RESTART>;
gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
wps {
label = "wps";
linux,code = <KEY_WPS_BUTTON>;
gpios = <&gpio 8 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
};
rtl8366s {
compatible = "realtek,rtl8366s";
gpio-sda = <&gpio 5 GPIO_ACTIVE_HIGH>;
gpio-sck = <&gpio 7 GPIO_ACTIVE_HIGH>;
realtek,initvals = <0x06 0x0108>;
mdio-bus {
#address-cells = <1>;
#size-cells = <0>;
status = "okay";
phy-mask = <0x10>;
phy4: ethernet-phy@4 {
reg = <4>;
phy-mode = "rgmii";
};
};
};
};
&usb1 {
#address-cells = <1>;
#size-cells = <0>;
status = "okay";
usb_ochi_port: port@1 {
reg = <1>;
#trigger-source-cells = <0>;
};
};
&usb2 {
#address-cells = <1>;
#size-cells = <0>;
status = "okay";
usb_echi_port: port@1 {
reg = <1>;
#trigger-source-cells = <0>;
};
};
&usb_phy {
status = "okay";
};
&pcie0 {
status = "okay";
ath9k0: wifi@0,11 {
compatible = "pci168c,0029";
reg = <0x8800 0 0 0 0>;
qca,no-eeprom;
#gpio-cells = <2>;
gpio-controller;
};
ath9k1: wifi@0,12 {
compatible = "pci168c,0029";
reg = <0x9000 0 0 0 0>;
qca,no-eeprom;
#gpio-cells = <2>;
gpio-controller;
};
};
&uart {
status = "okay";
};
&pll {
clocks = <&extosc>;
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "u-boot";
reg = <0x000000 0x040000>;
read-only;
};
partition@40000 {
label = "config";
reg = <0x040000 0x010000>;
read-only;
};
partition@50000 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x050000 0x610000>;
};
caldata: partition@60000 {
label = "caldata";
reg = <0x660000 0x010000>;
read-only;
};
partition@670000 {
label = "unknown";
reg = <0x670000 0x190000>;
read-only;
};
};
};
};
&eth0 {
status = "okay";
pll-data = <0x11110000 0x00001099 0x00991099>;
fixed-link {
speed = <1000>;
full-duplex;
};
};
&eth1 {
status = "okay";
pll-data = <0x11110000 0x00001099 0x00991099>;
phy-handle = <&phy4>;
};