openwrt/target/linux/mvebu/patches-4.19/531-net-mvneta-Add-support-for-2500Mbps-SGMII.patch

From da58a931f248f423f917c3a0b3c94303aa30a738 Mon Sep 17 00:00:00 2001
From: Maxime Chevallier <maxime.chevallier@bootlin.com>
Date: Tue, 25 Sep 2018 15:59:39 +0200
Subject: [PATCH] net: mvneta: Add support for 2500Mbps SGMII

The mvneta controller can handle speeds up to 2500Mbps on the SGMII
interface. This relies on serdes configuration, the lane must be
configured at 3.125Gbps and we can't use in-band autoneg at that speed.

The main issue when supporting that speed on this particular controller
is that the link partner can send ethernet frames with a shortened
preamble, which if not explicitly enabled in the controller will cause
unexpected behaviours.

This was tested on Armada 385, with the comphy configuration done in
bootloader.

Signed-off-by: Maxime Chevallier <maxime.chevallier@bootlin.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
---
 drivers/net/ethernet/marvell/mvneta.c | 27 +++++++++++++++++++++++----
 1 file changed, 23 insertions(+), 4 deletions(-)

--- a/drivers/net/ethernet/marvell/mvneta.c
+++ b/drivers/net/ethernet/marvell/mvneta.c
@@ -221,6 +221,8 @@
 #define      MVNETA_GMAC_AN_FLOW_CTRL_EN         BIT(11)
 #define      MVNETA_GMAC_CONFIG_FULL_DUPLEX      BIT(12)
 #define      MVNETA_GMAC_AN_DUPLEX_EN            BIT(13)
+#define MVNETA_GMAC_CTRL_4                       0x2c90
+#define      MVNETA_GMAC4_SHORT_PREAMBLE_ENABLE  BIT(1)
 #define MVNETA_MIB_COUNTERS_BASE                 0x3000
 #define      MVNETA_MIB_LATE_COLLISION           0x7c
 #define MVNETA_DA_FILT_SPEC_MCAST                0x3400
@@ -3358,6 +3360,7 @@ static void mvneta_validate(struct net_d
 	if (state->interface != PHY_INTERFACE_MODE_NA &&
 	    state->interface != PHY_INTERFACE_MODE_QSGMII &&
 	    state->interface != PHY_INTERFACE_MODE_SGMII &&
+	    state->interface != PHY_INTERFACE_MODE_2500BASEX &&
 	    !phy_interface_mode_is_8023z(state->interface) &&
 	    !phy_interface_mode_is_rgmii(state->interface)) {
 		bitmap_zero(supported, __ETHTOOL_LINK_MODE_MASK_NBITS);
@@ -3370,9 +3373,15 @@ static void mvneta_validate(struct net_d
 
 	/* Asymmetric pause is unsupported */
 	phylink_set(mask, Pause);
-	/* Half-duplex at speeds higher than 100Mbit is unsupported */
-	phylink_set(mask, 1000baseT_Full);
-	phylink_set(mask, 1000baseX_Full);
+
+	/* We cannot use 1Gbps when using the 2.5G interface. */
+	if (state->interface == PHY_INTERFACE_MODE_2500BASEX) {
+		phylink_set(mask, 2500baseT_Full);
+		phylink_set(mask, 2500baseX_Full);
+	} else {
+		phylink_set(mask, 1000baseT_Full);
+		phylink_set(mask, 1000baseX_Full);
+	}
 
 	if (!phy_interface_mode_is_8023z(state->interface)) {
 		/* 10M and 100M are only supported in non-802.3z mode */
@@ -3433,12 +3442,14 @@ static void mvneta_mac_config(struct net
 	struct mvneta_port *pp = netdev_priv(ndev);
 	u32 new_ctrl0, gmac_ctrl0 = mvreg_read(pp, MVNETA_GMAC_CTRL_0);
 	u32 new_ctrl2, gmac_ctrl2 = mvreg_read(pp, MVNETA_GMAC_CTRL_2);
+	u32 new_ctrl4, gmac_ctrl4 = mvreg_read(pp, MVNETA_GMAC_CTRL_4);
 	u32 new_clk, gmac_clk = mvreg_read(pp, MVNETA_GMAC_CLOCK_DIVIDER);
 	u32 new_an, gmac_an = mvreg_read(pp, MVNETA_GMAC_AUTONEG_CONFIG);
 
 	new_ctrl0 = gmac_ctrl0 & ~MVNETA_GMAC0_PORT_1000BASE_X;
 	new_ctrl2 = gmac_ctrl2 & ~(MVNETA_GMAC2_INBAND_AN_ENABLE |
 				   MVNETA_GMAC2_PORT_RESET);
+	new_ctrl4 = gmac_ctrl4 & ~(MVNETA_GMAC4_SHORT_PREAMBLE_ENABLE);
 	new_clk = gmac_clk & ~MVNETA_GMAC_1MS_CLOCK_ENABLE;
 	new_an = gmac_an & ~(MVNETA_GMAC_INBAND_AN_ENABLE |
 			     MVNETA_GMAC_INBAND_RESTART_AN |
@@ -3471,7 +3482,7 @@ static void mvneta_mac_config(struct net
 		if (state->duplex)
 			new_an |= MVNETA_GMAC_CONFIG_FULL_DUPLEX;
 
-		if (state->speed == SPEED_1000)
+		if (state->speed == SPEED_1000 || state->speed == SPEED_2500)
 			new_an |= MVNETA_GMAC_CONFIG_GMII_SPEED;
 		else if (state->speed == SPEED_100)
 			new_an |= MVNETA_GMAC_CONFIG_MII_SPEED;
@@ -3510,10 +3521,18 @@ static void mvneta_mac_config(struct net
 			    MVNETA_GMAC_FORCE_LINK_DOWN);
 	}
 
+	/* When at 2.5G, the link partner can send frames with shortened
+	 * preambles.
+	 */
+	if (state->speed == SPEED_2500)
+		new_ctrl4 |= MVNETA_GMAC4_SHORT_PREAMBLE_ENABLE;
+
 	if (new_ctrl0 != gmac_ctrl0)
 		mvreg_write(pp, MVNETA_GMAC_CTRL_0, new_ctrl0);
 	if (new_ctrl2 != gmac_ctrl2)
 		mvreg_write(pp, MVNETA_GMAC_CTRL_2, new_ctrl2);
+	if (new_ctrl4 != gmac_ctrl4)
+		mvreg_write(pp, MVNETA_GMAC_CTRL_4, new_ctrl4);
 	if (new_clk != gmac_clk)
 		mvreg_write(pp, MVNETA_GMAC_CLOCK_DIVIDER, new_clk);
 	if (new_an != gmac_an)