The missing dissolve of the dummy decorator input component resulted in
problems when using the themed_decorator when repeatedly opening and
closing windows. In contrast to the default decorator, the themed
decorator creates and destroys nitpicker sessions per window.
Added a new constructor that takes the entrypoint as constructor
argument. The original constructor retrieves the entrypoint from the
Genode environment. This does not allow to use a different entrypoint.
Replace former rtt_sec attribute of the <config> tag by more specific
(and still optional) attributes for timeouts used in the NIC router
(these are also the default values):
<config dhcp_discover_timeout_sec="10"
dhcp_request_timeout_sec="10"
dhcp_offer_timeout_sec="10"
udp_idle_timeout_sec="30"
tcp_idle_timeout_sec="600"
tcp_max_segm_lifetime_sec="30">
Details about the new attributes can be found in the README of the router.
Issue #2590
On x86 64 bit with SeL4, the test needs around 80MB that must be
completely composed of 4KB-pages due to current limitations of the SeL4
port. Thus, Core must flush the page table caches pretty often during
the test which is an expensive high-prior operation and makes it
impossible to provide a highly precise time.
Multi-wraps
-----------
Previously, on every new timeout, we programmed registers LR=timeout and
CMP=0. The counter than counted from LR down to 0, triggered the IRQ,
jumped back to LR, and counted down again. If one installed small
timeouts (< 1000 us), it was likely that the counter wrapped multiple
times before we were able to read it out. Initially, this was not a big
issue as the additional wraps were simply ignored and the amount of time
lost through this was not big. But when we want to do correct rate
limitation, multiple wraps cause an overflow in the additional
calculations, and this has a big effect on the resulting time value.
Thus, we now program the counter to start from ~0 and count down to 0.
We set CMP=~0-timeout so that the timer still triggers the IRQ at the right
time. The counter continues counting down after the IRQ has triggered until
we install a new timeout. We do not consider anymore that the counter wraps.
The maximum timeout is set to half the maximum counter value, so, we should
be able to install a new timeout before the counter wraps.
Rate limit for time updates
---------------------------
In the time span between two interrupts we have to remember how many ticks
we have already added to the time value. This is because at each call of
curr_time we can only see how many ticks have passed since the last call of
schedule_timeout and not since the last call of curr_time. But we want to
limit the rate of time updates in curr_time. With the member for ticks that
were already added since the last call to schedule_timeout we can then
calculate how many are yet to be added.
* integrate rump's contrib code into Genode's build system and build what is
required by Genode, only
* checkout needed NetBSD sources directly from CVS
fixes#2589
In case the video geometry (WxH) is larger than the current size of
the framebuffer, match its size and let libav do the scaling. This
enables the playback of 1080p movies on smaller screens.
Issue #2583.
