diff --git a/netinfra/switches/core-sw01-ch1-to-lacp.cmds b/netinfra/switches/core-sw01-ch1-to-lacp.cmds
new file mode 100644
index 0000000..72cb1ea
--- /dev/null
+++ b/netinfra/switches/core-sw01-ch1-to-lacp.cmds
@@ -0,0 +1,25 @@
+! #369/#394: Convert cross-rack trunk ch1 from static (mode=on) to LACP
+! Switch: core-sw01 (Dell PowerConnect 5448, rack 5)
+! WHEN: Friday maintenance window — BOTH switches must change together
+! RISK: Brief storage-net outage during transition (seconds)
+!
+! Current: g13-g16 in ch1, mode=on (static, no failure detection)
+! Target:  g13-g16 in ch1, mode=auto (LACP active partner negotiation)
+!
+! NOTE: core-sw01 hash stays layer-2-3 (hardware limit — best available)
+!       tor3-stor hash stays layer-2-3-4 (already set)
+!
+! IMPORTANT: Run this SIMULTANEOUSLY with tor3-stor change.
+!   If one side is LACP and other is static, trunk goes down until
+!   both sides match. Plan for ~30s storage-net outage.
+!
+enable
+configure
+interface range ethernet g13-g16
+  no channel-group
+  channel-group 1 mode auto
+exit
+exit
+show interfaces status port-channel 1
+show lacp port-channel 1
+copy running-config startup-config
diff --git a/netinfra/switches/tor3-stor-ch1-to-lacp.cmds b/netinfra/switches/tor3-stor-ch1-to-lacp.cmds
new file mode 100644
index 0000000..a1119c8
--- /dev/null
+++ b/netinfra/switches/tor3-stor-ch1-to-lacp.cmds
@@ -0,0 +1,24 @@
+! #369/#394: Convert cross-rack trunk ch1 from static (mode=on) to LACP
+! Switch: pfv-r3-tor-stor (Dell PowerConnect 5324 / "Neyland 24T", rack 3)
+! WHEN: Friday maintenance window — BOTH switches must change together
+! RISK: Brief storage-net outage during transition (seconds)
+!
+! Current: g20-g23 in ch1, mode=on (static, no failure detection)
+! Target:  g20-g23 in ch1, LACP active
+!
+! Radlan CLI syntax (different from DNOS on core-sw01)
+! Verify exact keywords on this switch first — 'show running-config'
+! will show the current ch1 config to confirm syntax.
+!
+! IMPORTANT: Run this SIMULTANEOUSLY with core-sw01 change.
+!
+enable
+configure
+interface range ethernet g20-g23
+  no channel-group
+  channel-group 1 mode active
+exit
+exit
+show interfaces status port-channel 1
+show lacp port-channel 1
+copy running-config startup-config