mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-25 08:21:14 +00:00
fce21ae4cc
Right now all brcm2708 patches are extracted from the non-mainline raspberrypi/linux git tree. Many of them are hacks and/or are unneeded in LEDE. Raspberry Pi is getting better and better mainline support so it would be nice to finally start maintaining patches in a cleaner way: 1) Backport patches accepted in upstream tree 2) Start using upstream drivers 3) Pick only these patches that are needed for more complete support Handling above tasks requires grouping patches - ideally using the same prefixes as generic ones. It means we should rename existing patches to use some high prefix. This will allow e.g. use 0xx for backported code. Signed-off-by: Rafał Miłecki <rafal@milecki.pl> Acked-by: Florian Fainelli <f.fainelli@gmail.com> Acked-by: Stijn Tintel <stijn@linux-ipv6.be>
38 lines
1.3 KiB
Diff
38 lines
1.3 KiB
Diff
From 599e7165ec6477139dae4f32a12e8d49d5dd8859 Mon Sep 17 00:00:00 2001
|
|
From: Eric Anholt <eric@anholt.net>
|
|
Date: Mon, 9 May 2016 17:28:18 -0700
|
|
Subject: [PATCH] clk: bcm2835: Mark GPIO clocks enabled at boot as critical.
|
|
|
|
These divide off of PLLD_PER and are used for the ethernet and wifi
|
|
PHYs source PLLs. Neither of them is currently represented by a phy
|
|
device that would grab the clock for us.
|
|
|
|
This keeps other drivers from killing the networking PHYs when they
|
|
disable their own clocks and trigger PLLD_PER's refcount going to 0.
|
|
|
|
v2: Skip marking as critical if they aren't on at boot.
|
|
|
|
Signed-off-by: Eric Anholt <eric@anholt.net>
|
|
---
|
|
drivers/clk/bcm/clk-bcm2835.c | 9 +++++++++
|
|
1 file changed, 9 insertions(+)
|
|
|
|
--- a/drivers/clk/bcm/clk-bcm2835.c
|
|
+++ b/drivers/clk/bcm/clk-bcm2835.c
|
|
@@ -1262,6 +1262,15 @@ static struct clk_hw *bcm2835_register_c
|
|
init.name = data->name;
|
|
init.flags = data->flags | CLK_IGNORE_UNUSED;
|
|
|
|
+ /*
|
|
+ * Some GPIO clocks for ethernet/wifi PLLs are marked as
|
|
+ * critical (since some platforms use them), but if the
|
|
+ * firmware didn't have them turned on then they clearly
|
|
+ * aren't actually critical.
|
|
+ */
|
|
+ if ((cprman_read(cprman, data->ctl_reg) & CM_ENABLE) == 0)
|
|
+ init.flags &= ~CLK_IS_CRITICAL;
|
|
+
|
|
if (data->is_vpu_clock) {
|
|
init.ops = &bcm2835_vpu_clock_clk_ops;
|
|
} else {
|