Andrew Pikler e8a97c05c1 ramips: add support for Cudy WR1300 ... Specifications: - SoC: MediaTek MT7621AT - RAM: 128 MB (DDR3) - Flash: 16 MB (SPI NOR) - WiFi: MediaTek MT7603E, MediaTek MT7612E - Switch: 1 WAN, 4 LAN (Gigabit) - Ports: 1 USB 3.0 - Buttons: Reset, WPS - LEDs: Power, System, Wan, Lan 1-4, WiFi 2.4G, WiFi 5G, WPS, USB - Power: DC 12V 1A tip positive UART Serial: 115200 baud Located on unpopulated 4 pin header near J4: J4 [o] Rx [o] Tx [o] GND [ ] Vcc - Do not connect Installation: Download and flash the manufacturer's built OpenWRT image available at http://www.cudytech.com/openwrt_software_download Install the new OpenWRT image via luci (System -> Backup/Flash firmware) Be sure to NOT keep settings. The force upgrade may need to be checked due to differences in router naming conventions. Recovery: - Loads only signed manufacture firmware due to bootloader RSA verification - serve tftp-recovery image as /recovery.bin on 192.168.1.88/24 - connect to any lan ethernet port - power on the device while holding the reset button - wait at least 8 seconds before releasing reset button for image to download - See http://www.cudytech.com/newsinfo/547425.html MAC addresses as verified by OEM firmware: use address source LAN *:f0 label WAN *:f1 label + 1 2g *:f0 label 5g *:f2 label + 2 The label MAC address is found in bdinfo 0xde00. Signed-off-by: Andrew Pikler <andrew.pikler@gmail.com> Signed-off-by: maurerr <mariusd84@gmail.com>		2021-09-01 08:07:34 +00:00
..
imagebuilder	imagebuilder: invoke bundle-libraries.sh w/o buildroot dirs in $PATH	2021-09-01 08:07:25 +00:00
linux	ramips: add support for Cudy WR1300	2021-09-01 08:07:34 +00:00
sdk	sdk: invoke bundle-libraries.sh w/o buildroot dirs in $PATH	2021-09-01 08:07:25 +00:00
toolchain	build: improve ccache support	2020-07-11 15:19:53 +02:00
Config.in	build: define PWM_SUPPORT arch feature flag	2021-09-01 08:07:01 +00:00
Makefile	build: make <subdir>/install opt-in, use it for target/ only	2017-02-09 13:51:35 +01:00