mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-27 17:18:59 +00:00
3c3825436e
Refreshed all patches. Remove upstreamed: - 600-ipv6-addrconf-call-ipv6_mc_up-for-non-Ethernet-inter.patch - 184-USB-serial-option-add-Wistron-Neweb-D19Q1.patch Fixes: - CVE-2020-8647 - CVE-2020-8648 (potentially) - CVE-2020-8649 Compile-tested on: cns3xxx Runtime-tested on: cns3xxx Signed-off-by: Koen Vandeputte <koen.vandeputte@ncentric.com>
105 lines
4.4 KiB
Diff
105 lines
4.4 KiB
Diff
From da58a931f248f423f917c3a0b3c94303aa30a738 Mon Sep 17 00:00:00 2001
|
|
From: Maxime Chevallier <maxime.chevallier@bootlin.com>
|
|
Date: Tue, 25 Sep 2018 15:59:39 +0200
|
|
Subject: [PATCH] net: mvneta: Add support for 2500Mbps SGMII
|
|
|
|
The mvneta controller can handle speeds up to 2500Mbps on the SGMII
|
|
interface. This relies on serdes configuration, the lane must be
|
|
configured at 3.125Gbps and we can't use in-band autoneg at that speed.
|
|
|
|
The main issue when supporting that speed on this particular controller
|
|
is that the link partner can send ethernet frames with a shortened
|
|
preamble, which if not explicitly enabled in the controller will cause
|
|
unexpected behaviours.
|
|
|
|
This was tested on Armada 385, with the comphy configuration done in
|
|
bootloader.
|
|
|
|
Signed-off-by: Maxime Chevallier <maxime.chevallier@bootlin.com>
|
|
Signed-off-by: David S. Miller <davem@davemloft.net>
|
|
---
|
|
drivers/net/ethernet/marvell/mvneta.c | 27 +++++++++++++++++++++++----
|
|
1 file changed, 23 insertions(+), 4 deletions(-)
|
|
|
|
--- a/drivers/net/ethernet/marvell/mvneta.c
|
|
+++ b/drivers/net/ethernet/marvell/mvneta.c
|
|
@@ -221,6 +221,8 @@
|
|
#define MVNETA_GMAC_AN_FLOW_CTRL_EN BIT(11)
|
|
#define MVNETA_GMAC_CONFIG_FULL_DUPLEX BIT(12)
|
|
#define MVNETA_GMAC_AN_DUPLEX_EN BIT(13)
|
|
+#define MVNETA_GMAC_CTRL_4 0x2c90
|
|
+#define MVNETA_GMAC4_SHORT_PREAMBLE_ENABLE BIT(1)
|
|
#define MVNETA_MIB_COUNTERS_BASE 0x3000
|
|
#define MVNETA_MIB_LATE_COLLISION 0x7c
|
|
#define MVNETA_DA_FILT_SPEC_MCAST 0x3400
|
|
@@ -3358,6 +3360,7 @@ static void mvneta_validate(struct net_d
|
|
if (state->interface != PHY_INTERFACE_MODE_NA &&
|
|
state->interface != PHY_INTERFACE_MODE_QSGMII &&
|
|
state->interface != PHY_INTERFACE_MODE_SGMII &&
|
|
+ state->interface != PHY_INTERFACE_MODE_2500BASEX &&
|
|
!phy_interface_mode_is_8023z(state->interface) &&
|
|
!phy_interface_mode_is_rgmii(state->interface)) {
|
|
bitmap_zero(supported, __ETHTOOL_LINK_MODE_MASK_NBITS);
|
|
@@ -3370,9 +3373,15 @@ static void mvneta_validate(struct net_d
|
|
|
|
/* Asymmetric pause is unsupported */
|
|
phylink_set(mask, Pause);
|
|
- /* Half-duplex at speeds higher than 100Mbit is unsupported */
|
|
- phylink_set(mask, 1000baseT_Full);
|
|
- phylink_set(mask, 1000baseX_Full);
|
|
+
|
|
+ /* We cannot use 1Gbps when using the 2.5G interface. */
|
|
+ if (state->interface == PHY_INTERFACE_MODE_2500BASEX) {
|
|
+ phylink_set(mask, 2500baseT_Full);
|
|
+ phylink_set(mask, 2500baseX_Full);
|
|
+ } else {
|
|
+ phylink_set(mask, 1000baseT_Full);
|
|
+ phylink_set(mask, 1000baseX_Full);
|
|
+ }
|
|
|
|
if (!phy_interface_mode_is_8023z(state->interface)) {
|
|
/* 10M and 100M are only supported in non-802.3z mode */
|
|
@@ -3433,12 +3442,14 @@ static void mvneta_mac_config(struct net
|
|
struct mvneta_port *pp = netdev_priv(ndev);
|
|
u32 new_ctrl0, gmac_ctrl0 = mvreg_read(pp, MVNETA_GMAC_CTRL_0);
|
|
u32 new_ctrl2, gmac_ctrl2 = mvreg_read(pp, MVNETA_GMAC_CTRL_2);
|
|
+ u32 new_ctrl4, gmac_ctrl4 = mvreg_read(pp, MVNETA_GMAC_CTRL_4);
|
|
u32 new_clk, gmac_clk = mvreg_read(pp, MVNETA_GMAC_CLOCK_DIVIDER);
|
|
u32 new_an, gmac_an = mvreg_read(pp, MVNETA_GMAC_AUTONEG_CONFIG);
|
|
|
|
new_ctrl0 = gmac_ctrl0 & ~MVNETA_GMAC0_PORT_1000BASE_X;
|
|
new_ctrl2 = gmac_ctrl2 & ~(MVNETA_GMAC2_INBAND_AN_ENABLE |
|
|
MVNETA_GMAC2_PORT_RESET);
|
|
+ new_ctrl4 = gmac_ctrl4 & ~(MVNETA_GMAC4_SHORT_PREAMBLE_ENABLE);
|
|
new_clk = gmac_clk & ~MVNETA_GMAC_1MS_CLOCK_ENABLE;
|
|
new_an = gmac_an & ~(MVNETA_GMAC_INBAND_AN_ENABLE |
|
|
MVNETA_GMAC_INBAND_RESTART_AN |
|
|
@@ -3471,7 +3482,7 @@ static void mvneta_mac_config(struct net
|
|
if (state->duplex)
|
|
new_an |= MVNETA_GMAC_CONFIG_FULL_DUPLEX;
|
|
|
|
- if (state->speed == SPEED_1000)
|
|
+ if (state->speed == SPEED_1000 || state->speed == SPEED_2500)
|
|
new_an |= MVNETA_GMAC_CONFIG_GMII_SPEED;
|
|
else if (state->speed == SPEED_100)
|
|
new_an |= MVNETA_GMAC_CONFIG_MII_SPEED;
|
|
@@ -3510,10 +3521,18 @@ static void mvneta_mac_config(struct net
|
|
MVNETA_GMAC_FORCE_LINK_DOWN);
|
|
}
|
|
|
|
+ /* When at 2.5G, the link partner can send frames with shortened
|
|
+ * preambles.
|
|
+ */
|
|
+ if (state->speed == SPEED_2500)
|
|
+ new_ctrl4 |= MVNETA_GMAC4_SHORT_PREAMBLE_ENABLE;
|
|
+
|
|
if (new_ctrl0 != gmac_ctrl0)
|
|
mvreg_write(pp, MVNETA_GMAC_CTRL_0, new_ctrl0);
|
|
if (new_ctrl2 != gmac_ctrl2)
|
|
mvreg_write(pp, MVNETA_GMAC_CTRL_2, new_ctrl2);
|
|
+ if (new_ctrl4 != gmac_ctrl4)
|
|
+ mvreg_write(pp, MVNETA_GMAC_CTRL_4, new_ctrl4);
|
|
if (new_clk != gmac_clk)
|
|
mvreg_write(pp, MVNETA_GMAC_CLOCK_DIVIDER, new_clk);
|
|
if (new_an != gmac_an)
|