openwrt/target/linux/mediatek/patches-4.14/0114-dt-bindings-usb-mtu3-remove-dummy-clocks-and-add-opt.patch
Stijn Tintel 64b53247c4 kernel: bump 4.14 to 4.14.44
Refresh patches.

Remove upstreamed patch:
generic/pending/181-net-usb-add-lte-modem-wistron-neweb-d18q1.patch
Update patches that no longer applies:
generic/hack/901-debloat_sock_diag.patch

Compile-tested on: x86/64.
Runtime-tested on: x86/64.

Signed-off-by: Stijn Tintel <stijn@linux-ipv6.be>
2018-05-29 00:53:15 +03:00

42 lines
1.7 KiB
Diff

From 2c90367440a0dbf9962e7a7f701b0e7a320d325a Mon Sep 17 00:00:00 2001
From: Chunfeng Yun <chunfeng.yun@mediatek.com>
Date: Fri, 13 Oct 2017 17:10:48 +0800
Subject: [PATCH 114/224] dt-bindings: usb: mtu3: remove dummy clocks and add
optional ones
Remove dummy clocks for usb wakeup and add optional ones for
mcu_bus and dma_bus bus.
Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
---
Documentation/devicetree/bindings/usb/mediatek,mtu3.txt | 10 ++++------
1 file changed, 4 insertions(+), 6 deletions(-)
--- a/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt
+++ b/Documentation/devicetree/bindings/usb/mediatek,mtu3.txt
@@ -14,9 +14,9 @@ Required properties:
- vusb33-supply : regulator of USB avdd3.3v
- clocks : a list of phandle + clock-specifier pairs, one for each
entry in clock-names
- - clock-names : must contain "sys_ck" and "ref_ck" for clock of controller;
- "wakeup_deb_p0" and "wakeup_deb_p1" are optional, they are
- depends on "mediatek,enable-wakeup"
+ - clock-names : must contain "sys_ck" for clock of controller,
+ the following clocks are optional:
+ "ref_ck", "mcu_ck" and "dam_ck";
- phys : a list of phandle + phy specifier pairs
- dr_mode : should be one of "host", "peripheral" or "otg",
refer to usb/generic.txt
@@ -65,9 +65,7 @@ ssusb: usb@11271000 {
clocks = <&topckgen CLK_TOP_USB30_SEL>, <&clk26m>,
<&pericfg CLK_PERI_USB0>,
<&pericfg CLK_PERI_USB1>;
- clock-names = "sys_ck", "ref_ck",
- "wakeup_deb_p0",
- "wakeup_deb_p1";
+ clock-names = "sys_ck", "ref_ck";
vusb33-supply = <&mt6397_vusb_reg>;
vbus-supply = <&usb_p0_vbus>;
extcon = <&extcon_usb>;