Daniel Golle e497c975d3 ramips: mt76x8: add support for Yuncore M300 ... Hardware: - SoC: MediaTek MT7628DAN (MIPS 580MHz) - Flash: 8 MiB Spansion S25FL064K - RAM: 64 MiB (built-into SoC) - WLAN: 2.4 GHz (MT7628) - Ethernet: 1x 10/100 Mbps WAN, 1x 10/100 LAN (MT7628) - Buttons: 1 Reset button - LEDs: 1x Red, 1x Green - Serial console: unpopulated header, 57600 8n1 (RX only) - Power: 12 VDC, 1 A There are unpopulated areas on the board for 5 GHz WiFi via PCIe as well as (most likely) Quectel EG25-G 4G module. As both are not populated on my board support for both is missing for now. Installation: The installation can be done via the recovery HTTP server which is built into the bootloader. Hold down the reset button while connecting the device to power and keep holding a bit more than 3 seconds. Connect to http://192.168.188.253/ and upload sysupgrade.bin file. Signed-off-by: Daniel Golle <daniel@makrotopia.org>		2024-08-15 03:19:30 +01:00
..
imagebuilder	imagebuilder: remove initramfs image files	2024-07-16 19:05:18 +02:00
linux	ramips: mt76x8: add support for Yuncore M300	2024-08-15 03:19:30 +01:00
llvm-bpf	build: use zstd for IB, toolchain, SDK and LLVM compression	2024-04-13 08:05:04 +02:00
sdk	build: use zstd for IB, toolchain, SDK and LLVM compression	2024-04-13 08:05:04 +02:00
toolchain	build: use zstd for IB, toolchain, SDK and LLVM compression	2024-04-13 08:05:04 +02:00
Config.in	loongarch64: new target	2024-05-04 14:14:16 +08:00
Makefile	build: add $(STAGING_DIR) and $(BIN_DIR) preparation to target and package subdir compile dependencies	2024-03-03 23:13:59 +01:00