Dongming Han 04d3308b62 ipq806x: add support for GL.iNet GL-B1300 ... This patch adds support for GL.iNet GL-B1300 Specification: - SOC: IPQ4028 / QCA Dakota - RAM: 256 MiB - FLASH: 32 MiB - ETH: Qualcomm Atheros QCA8075 Gigabit Switch (2 x LAN, 1 x WAN) - USB: 1 x 3.0 (via Synopsys DesignWare DWC3 controller in the SoC) - WLAN1: Qualcomm Atheros QCA4028 2.4GHz 802.11bgn 2:2x2 - WLAN2: Qualcomm Atheros QCA4028 5GHz 802.11a/n/ac 2:2x2 - INPUT: one reset and one WPS button - LEDS: 3 leds: Power, WIFI(only for 2.4G currently), and one reserved - UART: 1 x UART on PCB (3.3V, TX, RX, GND) - 115200 8N1 Installation: Method 1: - use serial port to stop uboot - uboot command: run lf Method 2: - push down reset button and power on - wait until three leds constantly on then release - upgrade by uboot web at http://192.168.1.1 Note: - the sysupgrade image need to be renamed to lede-gl-b1300.bin in both method. - the sysupgrade image can be automatically downloaded if tftp server at 192.168.1.2 have that file. - the wifi led will be flashing when writing image. Signed-off-by: Dongming Han <handongming@gl-inet.com>		2018-02-14 09:40:32 +01:00
..
board.d	ipq806x: add support for GL.iNet GL-B1300	2018-02-14 09:40:32 +01:00
hotplug.d	ipq806x: add support for GL.iNet GL-B1300	2018-02-14 09:40:32 +01:00
init.d	ipq806x: convert to dt-based board-detection	2018-01-13 07:33:03 +01:00
diag.sh	base-files: unify get_dt_led helper function	2017-12-14 09:29:30 +01:00
inittab	image / basefiles: make console password configurable	2016-04-18 21:53:07 +02:00