openwrt/package/firmware/ipq-wifi
Hans Geiblinger a9071d02b5 ipq40xx: Add support for Linksys MR8300 (Dallas)
The Linksys MR8300 is based on QCA4019 and QCA9888
and provides three, independent radios.
NAND provides two, alternate kernel/firmware images
with fail-over provided by the OEM U-Boot.

Hardware Highlights:

SoC: IPQ4019 at 717 MHz (4 CPUs)
RAM: 512MB RAM

SoC:	Qualcomm IPQ4019 at 717 MHz (4 CPUs)
RAM:	512M DDR3
FLASH:	256 MB NAND (Winbond W29N02GV, 8-bit parallel)
ETH:	Qualcomm QCA8075 (4x GigE LAN, 1x GigE Internet Ethernet Jacks)
BTN:	Reset and WPS
USB:	USB3.0, single port on rear with LED
SERIAL:	Serial pads internal (unpopulated)
LED:	Four status lights on top + USB LED
WIFI1:	2x2:2 QCA4019 2.4 GHz radio on ch. 1-14
WIFI2:  2x2:2 QCA4019 5 GHz radio on ch. 36-64
WIFI3:  2x2:2 QCA9888 5 GHz radio on ch. 100-165

Support is based on the already supported EA8300.
Key differences:
	EA8300 has 256MB RAM where MR8300 has 512MB RAM.
	MR8300 has a revised top panel LED setup.

Installation:
"Factory" images may be installed directly through the OEM GUI using
URL: https://ip-of-router/fwupdate.html (Typically 192.168.1.1)

Signed-off-by: Hans Geiblinger <cybrnook2002@yahoo.com>
[copied Hardware-highlights from EA8300. Fixed alphabetical order.
fixed commit subject, removed bogus unit-address of keys,
fixed author (used Signed-off-By to From:) ]
Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
2020-09-25 19:31:51 +02:00
..
board-8dev_habanero-dvk.qca4019 ipq40xx: add support for 8devices Habanero DVK 2020-03-09 00:53:50 +01:00
board-aruba_ap-303.qca4019 ipq-wifi: add BDF for Aruba AP-303 2019-12-20 17:48:52 +01:00
board-avm_fritzrepeater-1200.qca4019 ipq-wifi: add AVM FRITZ!Repeater 1200 bdf 2019-10-23 01:17:28 +02:00
board-buffalo_wtr-m2133hp.qca4019 ipq40xx: add support for Buffalo WTR-M2133HP 2020-07-08 16:07:05 +02:00
board-buffalo_wtr-m2133hp.qca9984 ipq40xx: add support for Buffalo WTR-M2133HP 2020-07-08 16:07:05 +02:00
board-cellc_rtl30vw.qca4019 ipq40xx: add support for Cell C RTL30VW 2020-04-10 15:22:26 +02:00
board-dlink_dap2610.qca4019 ipq40xx: Add support for D-Link DAP-2610 2020-01-26 01:20:45 +01:00
board-edgecore_ecw5211.qca4019 ipq40xx: add Edgecore ECW5211 support 2020-09-17 08:43:03 +02:00
board-edgecore_ecw5410.qca9984 ipq806x: add Edgecore ECW5410 support 2020-09-17 08:42:17 +02:00
board-edgecore_oap100.qca4019 ipq40xx: add Edgecore OAP-100 support 2020-09-17 08:43:07 +02:00
board-engenius_eap2200.qca4019 ipq40xx: add support for EnGenius EAP2200 2020-02-28 22:29:10 +01:00
board-engenius_eap2200.qca9888 ipq40xx: add support for EnGenius EAP2200 2020-02-28 22:29:10 +01:00
board-engenius_emd1.qca4019 ipq40xx: add support for EnGenius EMD1 2020-01-26 01:20:45 +01:00
board-engenius_emr3500.qca4019 ipq40xx: add support for EnGenius EMR3500 2020-06-13 14:38:03 +02:00
board-ezviz_cs-w3-wd1200g-eup.qca4019 ipq40xx: add support for EZVIZ CS-W3-WD1200G EUP 2020-01-12 15:57:58 +01:00
board-glinet_gl-s1300.qca4019 ipq40xx: add support for GL.iNet GL-S1300 2020-07-08 16:07:05 +02:00
board-linksys_ea8300.qca4019 ipq40xx: Add support for Linksys EA8300 (Dallas) 2019-05-18 13:43:54 +02:00
board-linksys_ea8300.qca9888 ipq40xx: Add support for Linksys EA8300 (Dallas) 2019-05-18 13:43:54 +02:00
board-linksys_mr8300-v0.qca4019 ipq40xx: Add support for Linksys MR8300 (Dallas) 2020-09-25 19:31:51 +02:00
board-linksys_mr8300-v0.qca9888 ipq40xx: Add support for Linksys MR8300 (Dallas) 2020-09-25 19:31:51 +02:00
board-luma_wrtq-329acn.qca4019 ipq40xx: add support for Luma Home WRTQ-329ACN 2020-09-25 19:30:19 +02:00
board-mobipromo_cm520-79f.qca4019 ipq40xx: add support for MobiPromo CM520-79F 2020-04-10 15:22:26 +02:00
board-qxwlan_e2600ac.qca4019 ipq-wifi: drop deprecated .bin support 2020-01-26 01:20:46 +01:00
Makefile ipq40xx: Add support for Linksys MR8300 (Dallas) 2020-09-25 19:31:51 +02:00