mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-26 17:01:14 +00:00
5572e0196a
TP-Link CPE710-v2 is an outdoor wireless CPE for 5 GHz with one Ethernet port based on the AP152 reference board. Compared to the CPE710-v1, the only change observed in hardware is that the mdio address of the ethernet physical changed from 0x4 to 0x0. Specifications: - SoC: QCA9563-AL3A MIPS 74kc @ 775MHz, AHB @ 258MHz - RAM: 128MiB DDR2 @ 650MHz - Flash: 16MiB SPI NOR Based on the GD25Q128 - Wi-Fi 5Ghz: ath10k chip (802.11ac for up to 867Mbps on 5GHz wireless data rate), based on the QCA9896 - Ethernet: one 1GbE port - 23dBi high-gain directional 2×2 MIMO parabolic antenna - Power, LAN, WLAN5G Blue LEDs Flashing instructions: Flash factory image through stock firmware WEB UI or through TFTP To get to TFTP recovery just hold reset button while powering on for around 30-40 seconds and release. Rename factory image to recovery.bin Stock TFTP server IP:192.168.0.100 Stock device TFTP address:192.168.0.254 Signed-off-by: Tim Noack <tim@noack.id> Link: https://github.com/openwrt/openwrt/pull/16637 Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
21 lines
332 B
Plaintext
21 lines
332 B
Plaintext
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
|
|
|
#include "qca9563_tplink_cpe710.dtsi"
|
|
|
|
/ {
|
|
model = "TP-Link CPE710 v2";
|
|
compatible = "tplink,cpe710-v2", "qca,qca9563";
|
|
};
|
|
|
|
&mdio0 {
|
|
phy0: ethernet-phy@0 {
|
|
reg = <0>;
|
|
reset-gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
|
|
};
|
|
};
|
|
|
|
ð0 {
|
|
phy-handle = <&phy0>;
|
|
phy-mode = "sgmii";
|
|
};
|