mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-28 01:28:59 +00:00
b7a8a54542
This patch adds support for the MikroTik RouterBOARD RB493G, ported from the ar71xx target. See https://routerboard.com/RB493G for details Specification: - SoC Qualcomm Atheros AR7161 - RAM: 256 MiB - Storage: 128MiB NAND - Ethernet: 9x 1000/100/10 Mbps - USB 1x 2.0 / 1.0 type A - PCIe: 3x Mini slot - MicroSD slot Working: - Board/system detection - Ethernet - SPI - NAND - LEDs - USB - Sysupgrade Enabled (but untested due to lack of hardware): - PCIe - ath79_pci_irq struct has the slot/pin/IRQ mappings if needed Installation methods: - tftp boot initramfs image, scp then flash via "sysupgrade -n" - nand boot existing OpenWrt, scp then flash via "sysupgrade -n" Notes: - initramfs image will not work if uncompressed image size over ~8.5Mb - The "rb4xx" drivers have been enabled Signed-off-by: Christopher Hill <ch6574@gmail.com>
45 lines
1.0 KiB
Plaintext
45 lines
1.0 KiB
Plaintext
CONFIG_AT803X_PHY=y
|
|
CONFIG_CRC16=y
|
|
CONFIG_CRYPTO_DEFLATE=y
|
|
CONFIG_GPIO_LATCH=y
|
|
CONFIG_GPIO_RB4XX=y
|
|
CONFIG_GPIO_WATCHDOG=y
|
|
CONFIG_GPIO_WATCHDOG_ARCH_INITCALL=y
|
|
CONFIG_LEDS_RESET=y
|
|
CONFIG_LZO_DECOMPRESS=y
|
|
CONFIG_MDIO_GPIO=y
|
|
CONFIG_MFD_RB4XX_CPLD=y
|
|
CONFIG_MIKROTIK=y
|
|
CONFIG_MIKROTIK_RB_SYSFS=y
|
|
CONFIG_MTD_NAND=y
|
|
CONFIG_MTD_NAND_AR934X=y
|
|
CONFIG_MTD_NAND_CORE=y
|
|
CONFIG_MTD_NAND_ECC=y
|
|
CONFIG_MTD_NAND_RB4XX=y
|
|
CONFIG_MTD_RAW_NAND=y
|
|
CONFIG_MTD_ROUTERBOOT_PARTS=y
|
|
CONFIG_MTD_SPI_NAND=y
|
|
CONFIG_MTD_SPI_NOR_USE_4K_SECTORS=y
|
|
CONFIG_MTD_SPLIT_MINOR_FW=y
|
|
CONFIG_MTD_UBI=y
|
|
CONFIG_MTD_UBI_BLOCK=y
|
|
CONFIG_MTD_UBI_WL_THRESHOLD=4096
|
|
CONFIG_MTD_UBI_BEB_LIMIT=20
|
|
# CONFIG_MTD_UBI_FASTMAP is not set
|
|
# CONFIG_MTD_UBI_GLUEBI is not set
|
|
CONFIG_NET_SWITCHDEV=y
|
|
CONFIG_PCI_AR71XX=y
|
|
CONFIG_PHY_AR7100_USB=y
|
|
CONFIG_PHY_AR7200_USB=y
|
|
CONFIG_REGULATOR=y
|
|
CONFIG_REGULATOR_FIXED_VOLTAGE=y
|
|
CONFIG_SPI_RB4XX=y
|
|
CONFIG_UBIFS_FS=y
|
|
CONFIG_UBIFS_FS_ADVANCED_COMPR=y
|
|
CONFIG_UBIFS_FS_LZO=y
|
|
CONFIG_UBIFS_FS_ZLIB=y
|
|
# CONFIG_UBIFS_FS_ZSTD is not set
|
|
CONFIG_WATCHDOG_CORE=y
|
|
CONFIG_ZLIB_DEFLATE=y
|
|
CONFIG_ZLIB_INFLATE=y
|