openwrt/target/linux
Sven Roederer b56bcfe3be ath79: add support for Ubiquiti Nanostation Loco M (XM)
This adds support for the Ubiquiti Nanostation Loco M (XM), which
has the same board/LEDs as the Bullet M XM, but different case and
antennas.

Specifications:
- AR7241 SoC @ 400 MHz
- 32 MB RAM
- 8 MB SPI flash
- 1x 10/100 Mbps Ethernet, 24 Vdc PoE-in
- NS Loco M2: built-in antenna: 8 dBi; AR9287
- NS Loco M5: built-in antenna: 13 dBi; 2T2R 5 GHz radio
- POWER/LAN green LEDs
- 4x RSSI LEDs (red, orange, green, green)
- UART (115200 8N1) on PCB

Flashing via WebUI:
  Upload the factory image via the stock firmware web UI.
  Note that only certain firmware versions accept unsigned
  images. Refer to the device's Wiki page for further information.

Flashing via TFTP:
  Same procedure as other NanoStation M boards.

- Use a pointy tool (e.g., pen cap, paper clip) and keep the reset
  button on the device or on the PoE supply pressed
- Power on the device via PoE (keep reset button pressed)
- Keep pressing until LEDs flash alternatively LED1+LED3 =>
  LED2+LED4 => LED1+LED3, etc.
- Release reset button
- The device starts a TFTP server at 192.168.1.20
- Set a static IP on the computer (e.g., 192.168.1.21/24)
- Upload via tftp the factory image:
  $ tftp 192.168.1.20
  tftp> bin
  tftp> trace
  tftp> put openwrt-ath79-generic-xxxxx-ubnt_nanostation-loco-m-squashfs-factory.bin

Tested on NanoStation Loco M2.

Signed-off-by: Sven Roederer <freifunk@it-solutions.geroedel.de>
Co-developed-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
2020-02-19 23:20:00 +01:00
..
apm821xx kernel: bump 4.19 to 4.19.101 2020-02-04 18:10:13 +01:00
ar71xx kernel: bump 4.14 to 4.14.167 2020-01-24 13:14:33 +01:00
arc770 arc770: gen_axs10x_sdcard_img.sh: switch to /bin/sh 2019-12-31 01:27:32 +01:00
archs38 archs38: gen_axs10x_sdcard_img.sh: switch to /bin/sh 2019-12-31 01:26:35 +01:00
armvirt treewide: Remove self from MAINTAINER entries 2019-12-23 13:18:04 -08:00
at91 at91: gen_at91_sdcard_img.sh: switch to /bin/sh 2019-12-31 01:25:44 +01:00
ath25 ath25: split up DEVICE_TITLE 2019-10-19 13:16:57 +02:00
ath79 ath79: add support for Ubiquiti Nanostation Loco M (XM) 2020-02-19 23:20:00 +01:00
bcm27xx brcm2708: rename target to bcm27xx 2020-02-14 14:10:51 +01:00
bcm47xx brcm47xx: rename target to bcm47xx 2020-02-14 14:10:51 +01:00
bcm53xx bcm53xx: build images for Luxul ABR-4500 and XBR-4500 routers 2020-02-07 09:31:22 +01:00
bcm63xx brcm63xx: rename target to bcm63xx 2020-02-14 14:10:51 +01:00
cns3xxx kernel: bump 4.19 to 4.19.86 2019-11-29 09:59:49 +01:00
gemini gemini: dns313_gen_hdd_img.sh: switch to /bin/sh 2019-12-31 01:23:24 +01:00
generic kernel: swconfig: make compatible with kernel 5.2 2020-02-12 22:15:14 +01:00
imx6 kernel: Deactivate CONFIG_SFP in generic config 2019-12-23 15:25:36 +01:00
ipq40xx kernel: bump 4.19 to 4.19.101 2020-02-04 18:10:13 +01:00
ipq806x kernel: bump 4.19 to 4.19.101 2020-02-04 18:10:13 +01:00
kirkwood kirkwood: exploit BOARD_NAME to set DEVICE_DTS and SUPPORTED_DEVICES 2020-01-23 14:27:12 +01:00
lantiq lantiq: tidy up image/Makefile 2020-01-24 18:52:41 +01:00
layerscape kernel: bump 4.14 to 4.14.169 2020-02-04 18:10:13 +01:00
malta malta: enable HighMem on MIPS32 2020-01-15 22:35:48 +01:00
mediatek kernel: bump 4.19 to 4.19.101 2020-02-04 18:10:13 +01:00
mpc85xx treewide: move mktplinkfw to tplink-v1-image in image-commands.mk 2020-01-08 16:15:29 +01:00
mvebu mvebu: image: align subtargets makefile names 2020-02-01 20:02:36 +01:00
mxs mxs: gen_sdcard_ext4_ext4.sh: use /bin/sh 2019-12-31 01:19:48 +01:00
octeon octeon: apply vendor_model scheme to device definition/image name 2020-01-26 23:00:26 +01:00
octeontx kernel: bump 4.14 to 4.14.160 2019-12-24 17:45:54 +01:00
omap omap: gen_omap_sdcard_img.sh: use /bin/sh 2019-12-31 01:17:09 +01:00
oxnas kernel: bump 4.14 to 4.14.158 2019-12-10 09:50:42 +01:00
pistachio kernel: bump 4.14 to 4.14.169 2020-02-04 18:10:13 +01:00
ramips ramips: fix HiWiFi HC5761A switch settings 2020-02-14 14:10:51 +01:00
rb532 rb532: gen_image.sh: use /bin/sh 2019-12-31 01:16:17 +01:00
samsung samsung: add subtarget condition for device 2020-01-03 00:04:22 +01:00
sunxi sunxi: backport increased SATA/AHCI DMA TX/RX FIFOs 2020-02-13 17:45:46 +01:00
tegra x86,tegra,mvebu: image: use common reproducible IMG_PART_SIGNATURE 2019-11-11 16:37:13 +01:00
uml treewide: Remove self from MAINTAINER entries 2019-12-23 13:18:04 -08:00
x86 kernel: bump 4.19 to 4.19.90 2019-12-24 15:34:43 +01:00
zynq zynq: derive DEVICE_DTS from device definition name 2020-01-21 14:26:04 +01:00
Makefile