Julien Dusser b893aa7992 ramips: add support for Linksys E5400 and clones ... Linksys E5400 is a 2.4/5GHz dual band AC router, based on MediaTek MT7628AN. This device is also sold as Linksys E2500v4, E5300 and E5350 with the same hardware, but software speed limitations in vendor firmwares. Specification: * SoC: MT7628AN (580 MHz) * RAM: DDR2 64 MiB * Flash: 16 MiB NOR (W25Q128BV) * Wi-Fi: * 2.4GHz: SoC Built-in * 5GHz: MT7612EN * Ethernet: 5x 100Mbps * Switch: SoC built-in * UART: * 115200, 8N1, 3.3V (real u-boot speed: 119050) * Pinout JB4: 1:[3V3] (TXD) (RXD) [NC] (GND) Flash Layout: 0x0000000-0x0030000 : "Bootloader" 0x0030000-0x0040000 : "Config" 0x0040000-0x0050000 : "Factory" 0x0050000-0x0ff0000 : "Kernel" 0x0ff0000-0x1000000 : "CBTinfo" MAC address: LAN: factory 0x28 WAN: LAN + 1 2.4G: LAN + 2 5G: LAN + 3 Installation: 1. Connect to UART, use LF as EOL (not CRLF) 2. Set IP address - Press 4 during boot - setenv serverip <TFTPSERVER_IP> - setenv ipaddr <DEVICE_IP> - setenv bootfile openwrt-ramips-mt76x8-linksys_e5400-initramfs-kernel.bin - saveenv - reset 3. Load Openwrt Kernel image from TFTP: - Press 1 during boot - IP and filename should be already set 4. Boot into OpenWrt and perform sysupgrade with sysupgrade image. Signed-off-by: Julien Dusser <julien.dusser@free.fr>		2022-12-18 21:24:57 +01:00
..
imagebuilder	imagebuilder: export SOURCE_DATE_EPOCH to environment	2022-04-10 00:56:38 +01:00
linux	ramips: add support for Linksys E5400 and clones	2022-12-18 21:24:57 +01:00
llvm-bpf	llvm-bpf: fix rebuild check for generating tarball	2021-11-26 11:37:19 +01:00
sdk	sdk: use git-src-full to allow Git versioning	2022-11-06 17:08:23 +01:00
toolchain	toolchain: switch packaged toolchain to tar.xz	2021-10-21 08:25:38 -10:00
Config.in	base-files: add eMMC sysupgrade support	2021-12-02 20:42:58 +00:00
Makefile	tools/llvm-bpf: move tarball packing to target/llvm-bpf	2021-11-22 12:00:40 +01:00