openwrt/target/linux/ar71xx/patches-4.9/104-spi-spi-ath79-support-multiple-internal-chip-select-.patch
Hauke Mehrtens 7bbf4117c6 ar71xx: Add kernel 4.9 support
This add support for kernel 4.9 to the ar71xx target.
It was compile tested with the generic, NAND and mikrotik subtarget.
Multiple members of the community tested it on their boards and did not
report any major problem so far.

Especially the NAND part received some changes to adapt to the new
kernel APIs. The serial driver hack used for the Arduino Yun was not
ported because the kernel changed there a lot.

Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
2017-10-11 22:32:39 +02:00

71 lines
1.9 KiB
Diff

From: Felix Fietkau <nbd@nbd.name>
Date: Fri, 9 Dec 2016 20:09:16 +0100
Subject: [PATCH] spi: spi-ath79: support multiple internal chip select
lines
Several devices with multiple flash chips use the internal chip select
lines. Don't assume that chip select 1 and above are GPIO lines.
Signed-off-by: Felix Fietkau <nbd@nbd.name>
---
--- a/drivers/spi/spi-ath79.c
+++ b/drivers/spi/spi-ath79.c
@@ -78,14 +78,16 @@ static void ath79_spi_chipselect(struct
ath79_spi_wr(sp, AR71XX_SPI_REG_IOC, sp->ioc_base);
}
- if (spi->chip_select) {
+ if (gpio_is_valid(spi->cs_gpio)) {
/* SPI is normally active-low */
gpio_set_value(spi->cs_gpio, cs_high);
} else {
+ u32 cs_bit = AR71XX_SPI_IOC_CS(spi->chip_select);
+
if (cs_high)
- sp->ioc_base |= AR71XX_SPI_IOC_CS0;
+ sp->ioc_base |= cs_bit;
else
- sp->ioc_base &= ~AR71XX_SPI_IOC_CS0;
+ sp->ioc_base &= ~cs_bit;
ath79_spi_wr(sp, AR71XX_SPI_REG_IOC, sp->ioc_base);
}
@@ -118,11 +120,8 @@ static int ath79_spi_setup_cs(struct spi
struct ath79_spi *sp = ath79_spidev_to_sp(spi);
int status;
- if (spi->chip_select && !gpio_is_valid(spi->cs_gpio))
- return -EINVAL;
-
status = 0;
- if (spi->chip_select) {
+ if (gpio_is_valid(spi->cs_gpio)) {
unsigned long flags;
flags = GPIOF_DIR_OUT;
@@ -134,10 +133,12 @@ static int ath79_spi_setup_cs(struct spi
status = gpio_request_one(spi->cs_gpio, flags,
dev_name(&spi->dev));
} else {
+ u32 cs_bit = AR71XX_SPI_IOC_CS(spi->chip_select);
+
if (spi->mode & SPI_CS_HIGH)
- sp->ioc_base &= ~AR71XX_SPI_IOC_CS0;
+ sp->ioc_base &= ~cs_bit;
else
- sp->ioc_base |= AR71XX_SPI_IOC_CS0;
+ sp->ioc_base |= cs_bit;
ath79_spi_wr(sp, AR71XX_SPI_REG_IOC, sp->ioc_base);
}
@@ -147,7 +148,7 @@ static int ath79_spi_setup_cs(struct spi
static void ath79_spi_cleanup_cs(struct spi_device *spi)
{
- if (spi->chip_select) {
+ if (gpio_is_valid(spi->cs_gpio)) {
gpio_free(spi->cs_gpio);
}
}