mirror of
https://github.com/openwrt/openwrt.git
synced 2025-03-25 05:25:27 +00:00
b3fdd931d1
This patch adds support for the Sitecom WL-341 v3 and other Sercomm IP1006RRv2 based boards for sysupgrade support and for the initial flash through pushbutton initiated recovery mode with the special partition table and fixes for the quirks and things required by the modified bootloader. There is a known bug, Wi-Fi is not working on my board probably because of the lack of RAM (the board only has 16MiB ram -- half of the normal amount for non rebadged versions, but there is an empty slot for another ram chip,) but I don't know for sure. The driver loads but hostapd fails to load so I think it's not related to the specific device except for the lack of RAM. Moreover, only 7 of the 11 onboard leds are confirmed working, it seems that one of the others is always on and the remaining ones are connected to the wireless card leds already recognized by OpenWrt [juhosg: reordered some parts in order to keep things sorted alphabetically] Signed-off-by: Marco Antonio Mauro <marcus90@gmail.com> SVN-Revision: 29910
This is the buildsystem for the OpenWrt Linux distribution. Please use "make menuconfig" to configure your appreciated configuration for the toolchain and firmware. You need to have installed gcc, binutils, patch, bzip2, flex, make, gettext, pkg-config, unzip, libz-dev and libc headers. Run "./scripts/feeds update" to get the latest package definitions defined in feeds.conf / feeds.conf.default respectively and "./scripts/feeds install" to install symlinks into "package/feeds/*". Use "make menuconfig" to configure your image. Simply running "make" will build your firmware. It will download all sources, build the cross-compile toolchain, the kernel and all choosen applications. You can use "scripts/flashing/flash.sh" for remotely updating your embedded system via tftp. The OpenWrt system is documented in docs/. You will need a LaTeX distribution and the tex4ht package to build the documentation. Type "make -C docs/" to build it. To build your own firmware you need to have access to a Linux, BSD or MacOSX system (case-sensitive filesystem required). Cygwin will not be supported because of the lack of case sensitiveness in the file system. Sunshine! Your OpenWrt Project http://openwrt.org