Kyson Lok abbfcc8525 ramips: add support for GL-inet GL-MT300N-V2 ... This patch adds supports for the GL-inet GL-MT300N-V2. Specification: - SoC: MediaTek MT7628AN - Flash: 16 MiB (W25Q128FVSG) - RAM: 128 MiB DDR - Ethernet: 1 x WAN (100 Mbps) and 1 x LAN (100 Mbps) - USB: 1 x USB 2.0 port - Button: 1 x switch button, 1 x reset button - LED: 3 x LEDS (system power led is not GPIO controller) - UART: 1 x UART on PCB (JP1: 3.3V, RX, TX, GND) Installation through Luci: - The original firmware is LEDE, so both LuCI or sysupgrade can be used. - Do not keep settings, for sysupgrade please use the -n option. Installation through bootloader webserver: - Plug power and hold reset button until red LED blink to bright. - Install sysupgrade image using web interface on 192.168.1.1. Signed-off-by: Kyson Lok <kysonlok@gmail.com> [match maximum image size with firmware partition] Signed-off-by: Mathias Kresin <dev@kresin.me>		2017-05-26 08:04:15 +02:00
..
board.d	ramips: add support for GL-inet GL-MT300N-V2	2017-05-26 08:04:15 +02:00
hotplug.d	ramips: use the ralink,mtd-eeprom device tree property	2016-11-09 20:22:59 +01:00
init.d	ramips: enablemodem: move /lib/ramips.sh to start()	2016-12-24 06:51:59 +01:00
uci-defaults	ramips: use rfkill for wps button on wlan only boards	2016-10-15 09:01:45 +02:00
diag.sh	ramips: add support for GL-inet GL-MT300N-V2	2017-05-26 08:04:15 +02:00
inittab	image / basefiles: make console password configurable	2016-04-18 21:53:07 +02:00