mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-23 07:22:33 +00:00
a21210fbb7
Since the beginning there's been an issue with initializing the Atheros
based MiniPCIe wireless cards. Here's an example of kerenel log:
OF: PCI: host bridge /soc/pcie@d0070000 ranges:
OF: PCI: MEM 0xe8000000..0xe8ffffff -> 0xe8000000
OF: PCI: IO 0xe9000000..0xe900ffff -> 0xe9000000
advk-pcie d0070000.pcie: link up
advk-pcie d0070000.pcie: PCI host bridge to bus 0000:00
pci_bus 0000:00: root bus resource [bus 00-ff]
pci_bus 0000:00: root bus resource [mem0xe8000000-0xe8ffffff]
pci_bus 0000:00: root bus resource [io 0x0000-0xffff](bus address[0xe9000000-0xe900ffff])
pci 0000:00:00.0: BAR 0: assigned [mem0xe8000000-0xe801ffff 64bit]
pci 0000:00:00.0: BAR 6: assigned [mem0xe8020000-0xe802ffff pref]
[...]
advk-pcie d0070000.pcie: Posted PIO Response Status: CA,0xe00 @ 0x3c
advk-pcie d0070000.pcie: Posted PIO Response Status: CA,0xe00 @ 0x44
advk-pcie d0070000.pcie: Posted PIO Response Status: CA,0xe00 @ 0x4
ath9k 0000:00:00.0: enabling device (0000 -> 0002)
advk-pcie d0070000.pcie: Posted PIO Response Status: CA,0xe00 @ 0x3c
advk-pcie d0070000.pcie: Posted PIO Response Status: CA,0xe00 @ 0xc
advk-pcie d0070000.pcie: Posted PIO Response Status: CA,0xe00 @ 0x4
advk-pcie d0070000.pcie: Posted PIO Response Status: CA,0xe00 @ 0x40
ath9k 0000:00:00.0: request_irq failed
advk-pcie d0070000.pcie: Posted PIO Response Status: CA,0xe00 @ 0x4
ath9k: probe of 0000:00:00.0 failed with error -22
The same happens for ath5k cards, while ath10k card didn't appear at
all (not detected):
OF: PCI: host bridge /soc/pcie@d0070000 ranges:
OF: PCI: MEM 0xe8000000..0xe8ffffff -> 0xe8000000
OF: PCI: IO 0xe9000000..0xe900ffff -> 0xe9000000
advk-pcie d0070000.pcie: link never came up
advk-pcie d0070000.pcie: PCI host bridge to bus 0000:00
pci_bus 0000:00: root bus resource [bus 00-ff]
pci_bus 0000:00: root bus resource [mem0xe8000000-0xe8ffffff]
pci_bus 0000:00: root bus resource [io 0x0000-0xffff](bus address[0xe9000000-0xe900ffff])
advk-pcie d0070000.pcie: config read/write timed out
Following the issue on esppressobin.net forum [1] the workaround seems
to be limiting the speed of PCIe bridge to 1st generation. This fixed
the initialisation of all tested Atheros wireless cards.
The change shouldn't affect the performance for wireless cards,
it could reduce the performance of storage controller cards but since
OpenWrt focuses on wireless connectivity, fixing compatibility with
wireless cards should be a priority.
For the record, the iwlwifi and mt76 cards were not affected by this
issue.
1. http://espressobin.net/forums/topic/which-pcie-wlan-cards-are-supported
Signed-off-by: Tomasz Maciej Nowak <tomek_n@o2.pl>
(cherry picked from commit
|
||
|---|---|---|
| .. | ||
| 002-add_powertables.patch | ||
| 003-add_switch_nodes.patch | ||
| 004-add_sata_disk_activity_trigger.patch | ||
| 005-linksys_hardcode_nand_ecc_settings.patch | ||
| 006-mvebu-Mangle-bootloader-s-kernel-arguments.patch | ||
| 100-find_active_root.patch | ||
| 102-revert_i2c_delay.patch | ||
| 103-remove-nand-driver-bug.patch | ||
| 104-linksys_mamba_disable_keep_config.patch | ||
| 105-build_new_dtbs.patch | ||
| 110-pxa3xxx_revert_irq_thread.patch | ||
| 205-armada-385-rd-mtd-partitions.patch | ||
| 206-ARM-mvebu-385-ap-Add-partitions.patch | ||
| 210-clearfog_switch_node.patch | ||
| 220-disable-untested-dsa-boards.patch | ||
| 230-armada-xp-linksys-mamba-broken-idle.patch | ||
| 300-mvneta-tx-queue-workaround.patch | ||
| 400-cpuidle-mvebu-indicate-failure-to-enter-deeper-sleep.patch | ||
| 401-pci-mvebu-time-out-reset-on-link-up.patch | ||
| 402-sfp-display-SFP-module-information.patch | ||
| 403-net-mvneta-convert-to-phylink.patch | ||
| 404-net-mvneta-hack-fix-phy_interface.patch | ||
| 405-net-mvneta-disable-MVNETA_CAUSE_PSC_SYNC_CHANGE-inte.patch | ||
| 406-net-mvneta-add-module-EEPROM-reading-support.patch | ||
| 407-phy-fixed-phy-remove-fixed_phy_update_state.patch | ||
| 408-sfp-move-module-eeprom-ethtool-access-into-netdev-co.patch | ||
| 409-sfp-use-netdev-sfp_bus-for-start-stop.patch | ||
| 410-sfp-hack-allow-marvell-10G-phy-support-to-use-SFP.patch | ||
| 411-sfp-add-sfp-compatible.patch | ||
| 412-ARM-dts-armada388-clearfog-emmc-on-clearfog-base.patch | ||
| 413-ARM-dts-armada388-clearfog-increase-speed-of-i2c0-to.patch | ||
| 414-ARM-dts-armada388-clearfog-add-SFP-module-support.patch | ||
| 415-ARM-dts-armada388-clearfog-document-MPP-usage.patch | ||
| 420-rtc-trimming-support.patch | ||
| 421-rtc-initialize.patch | ||
| 423-ARM-dts-armada-385-linksys-Disable-internal-RTC.patch | ||
| 450-reprobe_sfp_phy.patch | ||
| 500-clk-mvebu-armada-37xx-periph-cosmetic-changes.patch | ||
| 501-clk-mvebu-armada-37xx-periph-prepare-cpu-clk-to-be-u.patch | ||
| 502-clk-mvebu-armada-37xx-periph-add-DVFS-support-for-cp.patch | ||
| 503-cpufreq-Add-DVFS-support-for-Armada-37xx.patch | ||
| 504-spi-a3700-Change-SPI-mode-before-asserting-chip-sele.patch | ||
| 505-arm64-dts-marvell-Fix-A37xx-UART0-register-size.patch | ||
| 506-arm64-dts-marvell-armada-37xx-add-UART-clock.patch | ||
| 507-arm64-dts-marvell-armada-37xx-add-nodes-allowing-cpu.patch | ||
| 508-cpufreq-armada-37xx-Fix-clock-leak.patch | ||
| 520-arm64-dts-marvell-armada37xx-Add-eth0-alias.patch | ||
| 521-esporessobin-dt-enable-spi-nor-on-i2c.patch | ||
| 524-PCI-aardvark-set-host-and-device-to-the-same-MAX-payload-size.patch | ||
| 526-PCI-aardvark-disable-LOS-state-by-default.patch | ||
| 527-PCI-aardvark-allow-to-specify-link-capability.patch | ||
| 528-arm64-dts-armada-3720-espressobin-set-max-link-to-ge.patch | ||
| 530-ATA-ahci_mvebu-enable-stop_engine-override.patch | ||
| 531-ATA-ahci_mvebu-pmp-stop-errata-226.patch | ||