Adrian Schmutzler 9573176300 ath79: use rssihigh LED instead of WAN LED for status indication ... Using the LED of network interfaces for status (boot/failsafe/...) indication is somewhat misleading, as the blinking might be mistaken for network activity. This uses rssi LEDs instead, which do not blink normally and thus are less ambiguous. The rssihigh LED has also been used consistently for the TP-Link CPE devices. Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>		2020-01-18 19:39:05 +01:00
..
base-files/etc/hotplug.d/ieee80211	ath79: split base-files into subtargets	2019-10-27 14:24:22 +01:00
dts	ath79: use rssihigh LED instead of WAN LED for status indication	2020-01-18 19:39:05 +01:00
files	ath79: add AR934x NAND Flash Controller driver	2019-10-20 15:32:53 +02:00
generic	ath79: add support for D-Link DIR-505	2020-01-15 20:38:46 +01:00
image	ath79: add support for Netgear WNDR4500 v3	2020-01-15 20:56:05 +01:00
nand	ath79: add support for Netgear WNDR4500 v3	2020-01-15 20:56:05 +01:00
patches-4.14	ath79: drop obsolete ehci hacks	2020-01-05 19:36:45 +01:00
patches-4.19	ath79: phy-ar7200-usb: adapt old behavior of arch/mips/ath79/dev-usb.c	2020-01-15 23:15:20 +01:00
tiny	ath79-tiny: enable 4k sectors	2019-12-19 22:41:57 +01:00
config-4.14	ath79: enable PCI for whole target	2019-10-27 18:02:55 +01:00
config-4.19	ath79: remove obsolete OF PCI related config symbols	2019-11-14 22:53:31 +01:00
Makefile	treewide: kernel: bump some targets to 4.19	2019-06-18 16:08:55 +02:00
modules.mk	ath79: add new OF only target for QCA MIPS silicon	2018-05-07 08:06:51 +02:00