mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-25 08:21:14 +00:00
2796ab85ed
* QCA IPQ4028
* 256 MB of RAM
* 32 MB of SPI NOR flash (mx25l25635e)
* 128 MB of SPI NAND flash (gd5f1gq4ucy1g)
* 2T2R 2.4 GHz
- QCA4019 hw1.0 (SoC)
- uses AP-DK03 BDF from QCA4019/hw1.0/board-2.bin
* 2T2R 5 GHz
- QCA4019 hw1.0 (SoC)
- uses AP-DK03 BDF from QCA4019/hw1.0/board-2.bin
* 2 fully software controllable GPIO-LEDs
* 2 additional GPIO-LEDs which also affect the SIM card detection
* 1x button (reset)
* 1x GPIO buzzer
* 1x USB (xHCI)
* 1x NGFF (USB-only with Dual-SIM support, untested)
* TTL pins are on board (R124 is next to GND, then follows: RX, TX, VCC)
* 2x gigabit ethernet
- phy@mdio4:
+ Manual: Ethernet port 0
+ gmac0 (ethaddr) in original firmware
+ 802.3af POE (HV version)
+ 24v passive POE (LV version)
- phy@mdio3:
+ Manual: Ethernet port 1
+ gmac1 (eth1addr) in original firmware
* DC Jack connector
+ 24-56V (HV version)
+ 12-24V (LV version)
The SPI NAND flash isn't supported at the moment.
The bootloader has to be updated before OpenWrt is installed to fix a
reboot problem. The nor-ipq40xx-single.img from
https://downloads.compex.com.sg/?dir=uploads/QSDK/QCA-Reference/WPJ428/b170123-IPQ40xx-Reference-Firmware
has to be downloaded and the transfered in u-boot via TFTP
set ipaddr 192.168.1.11
set serverip 192.168.1.10
ping ${serverip}
tftpboot 0x84000000 nor-ipq40xx-single.img
imgaddr=0x84000000 && source $imgaddr:script
The sysupgrade image can be installed directly on flash using u-boot:
sf probe
tftpboot 0x84000000 openwrt-ipq40xx-compex_wpj428-squashfs-sysupgrade.bin
sf erase 0x00180000 +$filesize
sf write 0x84000000 0x00180000 $filesize
bootipq
The initramfs image can be started using
tftpboot 0x82000000 openwrt-ipq40xx-compex_wpj428-initramfs-fit-uImage.itb
set fdt_high 0x83000000
bootm 0x82000000
The used SIM card slot can be changed using
# slot 1 (also enables orange LED)
echo 1 > /sys/class/gpio/gpio3/value
# slot 2
echo 0 > /sys/class/gpio/gpio3/value
It can be checked whether a SIM card is inserted in the current slot and
the red LED is subsequently on via:
echo 2 > /sys/class/gpio/export
cat /sys/class/gpio/gpio2/value
Signed-off-by: Sven Eckelmann <sven@narfation.org>
|
||
|---|---|---|
| .. | ||
| 017-qcom-ipq4019-add-cpu-operating-points-for-cpufreq-su.patch | ||
| 030-mtd-nand-Use-standard-large-page-OOB-layout-when-usi.patch | ||
| 031-mtd-nand-use-usual-return-values-for-the-erase-hook.patch | ||
| 040-dmaengine-qcom-bam-Process-multiple-pending-descript.patch | ||
| 050-0002-mtd-nand-qcom-add-command-elements-in-BAM-transactio.patch | ||
| 050-0003-mtd-nand-qcom-support-for-command-descriptor-formati.patch | ||
| 050-0004-mtd-nand-provide-several-helpers-to-do-common-NAND-o.patch | ||
| 050-0005-mtd-nand-force-drivers-to-explicitly-send-READ-PROG-.patch | ||
| 050-0006-mtd-nand-qcom-Add-a-NULL-check-for-devm_kasprintf.patch | ||
| 059-ARM-cpuidle-Add-cpuidle-support-for-QCOM-cpus.patch | ||
| 069-arm-boot-add-dts-files.patch | ||
| 070-qcom-spm-fix-probe-order.patch | ||
| 101-ARM-dts-ipq4019-Add-a-few-peripheral-nodes.patch | ||
| 102-ARM-dts-ipq4019-fix-PCI-range.patch | ||
| 104-mtd-nand-add-Winbond-manufacturer-and-chip.patch | ||
| 305-qcom-ipq4019-use-v2-of-the-kpss-bringup-mechanism.patch | ||
| 306-qcom-ipq4019-add-USB-nodes-to-ipq4019-SoC-device-tre.patch | ||
| 307-ARM-qcom-Add-IPQ4019-SoC-support.patch | ||
| 310-msm-adhoc-bus-support.patch | ||
| 400-mtd-ubi-add-quirk-to-autoload-ubi-on-rt-ac58u.patch | ||
| 605-net-IPQ4019-needs-rfs-vlan_tag-callbacks-in.patch | ||
| 700-net-add-qualcomm-mdio-and-phy.patch | ||
| 701-dts-ipq4019-add-mdio-node.patch | ||
| 702-dts-ipq4019-add-PHY-switch-nodes.patch | ||
| 710-net-add-qualcomm-essedma-ethernet-driver.patch | ||
| 711-dts-ipq4019-add-ethernet-essedma-node.patch | ||
| 712-mr33-essedma.patch | ||
| 820-qcom-ipq4019-Add-IPQ4019-USB-HS-SS-PHY-drivers.patch | ||
| 830-usb-dwc3-register-qca-ipq4019-dwc3-in-dwc3-of-simple.patch | ||
| 850-soc-add-qualcomm-syscon.patch | ||
| 864-03-dts-ipq4019-ap-dk01-add-tcsr-config-to-dtsi.patch | ||
| 864-05-dts-ipq4019-ap-dk01-remove-spi-chip-node-from-dtsi.patch | ||
| 864-07-dts-ipq4019-ap-dk01.1-c1-add-spi-and-ram-nodes.patch | ||
| 864-08-dts-ipq4019-ap-dk01.1-c1-add-compatible-string.patch | ||
| 900-clk-fix.patch | ||