mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-20 14:13:16 +00:00
86e18f6706
* QCA IPQ401x
* 256 MB of RAM
* 32 MB of SPI NOR flash (s25fl256s1)
- 2x 15 MB available; but one of the 15 MB regions is the recovery image
* 2T2R 2.4 GHz
- QCA4019 hw1.0 (SoC)
- requires special BDF in QCA4019/hw1.0/board-2.bin with
bus=ahb,bmi-chip-id=0,bmi-board-id=16,variant=OM-A42
* 2T2R 5 GHz
- QCA4019 hw1.0 (SoC)
- requires special BDF in QCA4019/hw1.0/board-2.bin with
bus=ahb,bmi-chip-id=0,bmi-board-id=17,variant=OM-A42
* multi-color LED (controlled via red/green/blue GPIOs)
* 1x button (reset; kmod-input-gpio-keys compatible)
* external watchdog
- triggered GPIO
* 1x USB (xHCI)
* TTL pins are on board (arrow points to VCC, then follows: GND, TX, RX)
* 2x gigabit ethernet
* powered only via POE
- 802.3af POE on Ethernet 1
- 18-24v passive POE (mode B) on Ethernet 2
The tool ap51-flash (https://github.com/ap51-flash/ap51-flash) should be
used to transfer the factory image to the u-boot when the device boots up.
Signed-off-by: Sven Eckelmann <sven.eckelmann@open-mesh.com>
|
||
|---|---|---|
| .. | ||
| qcom-ipq4019-a42.dts | ||
| qcom-ipq4019-bus.dtsi | ||
| qcom-ipq4019-fritz4040.dts | ||
| qcom-ipq8064-ap148.dts | ||
| qcom-ipq8064-c2600.dts | ||
| qcom-ipq8064-d7800.dts | ||
| qcom-ipq8064-db149.dts | ||
| qcom-ipq8064-ea8500.dts | ||
| qcom-ipq8064-r7500.dts | ||
| qcom-ipq8064-r7500v2.dts | ||
| qcom-ipq8064-vr2600v.dts | ||
| qcom-ipq8064.dtsi | ||
| qcom-ipq8065-nbg6817.dts | ||
| qcom-ipq8065-r7800.dts | ||
| qcom-ipq8065-v1.0.dtsi | ||
| qcom-ipq8065.dtsi | ||