Lech Perczak 82b5984636 ath79: ZTE MF286[,A,R]: fix WLAN LED mapping ... The default configuration of pinctrl for GPIO19 set by U-boot was not a GPIO, but an alternate function, which prevented the GPIO hog from working. Set GPIO19 into GPIO mode to allow the hog to work, then the ath10k LED output can control the state of actual LED properly. Link: <https://github.com/openwrt/openwrt/pull/9941> Signed-off-by: Lech Perczak <lech.perczak@gmail.com>		2022-06-05 21:19:32 +02:00
..
base-files/etc/hotplug.d/ieee80211	ath79: migrate Archer C5 5GHz radio device paths	2022-03-31 18:07:29 +02:00
dts	ath79: ZTE MF286[,A,R]: fix WLAN LED mapping	2022-06-05 21:19:32 +02:00
files	ath79: add support for reset key on MikroTik RB912UAG-2HPnD	2022-01-19 16:40:12 +01:00
generic	ath79: fix label MAC address for D-Link DIR-825B1	2022-05-29 00:00:52 +02:00
image	ath79: NanoBeam M5 fix target_devices	2022-05-21 19:24:40 +02:00
mikrotik	ath79: add support for MikroTik hAP (RB951Ui-2nD)	2022-05-21 13:54:08 +02:00
nand	ath79: ZTE MF286[A,R]: add "Power button blocker" GPIO switch	2022-05-15 16:32:40 +02:00
patches-5.10	kernel: bump 5.10 to 5.10.114	2022-05-16 20:26:38 +02:00
patches-5.15	kernel: bump 5.15 to 5.15.38	2022-05-09 20:49:50 +01:00
tiny	ath79: Move TPLink WPA8630Pv2 to ath79-tiny target	2022-04-09 19:31:46 +02:00
config-5.10	ath79: add support for reset key on MikroTik RB912UAG-2HPnD	2022-01-19 16:40:12 +01:00
config-5.15	kernel: move some symbols to generic config	2022-04-09 19:31:46 +02:00
Makefile	ath79: switch to Kernel 5.10	2021-12-21 21:38:52 +01:00
modules.mk