openwrt/target/linux/ath79/dts/qca9563_tplink_tl-wpa8630p-v2.dtsi
Adrian Schmutzler 7ef7dbaf70 ath79: add support for TP-Link TL-WPA8630 v1
This ports the TP-Link TL-WPA8630 v1 from ar71xx to ath79.

Specifications:

SoC: QCA9563
CPU: 750 MHz
Flash/RAM: 8 / 128 MiB
Ethernet: 3x 1G ports (QCA8337 switch)
WLAN: 2.4 GHz b/g/n, 5 GHz a/n/ac (ath10k)

Buttons, LEDs and network setup appear to be almost identical
to the v2 revision.

Powerline interface is connected to switch port 5 (Label LAN4).

Installation:

No "fresh" device was available for testing the factory image.

It is not known whether flashing via OEM firmware GUI is possible
or not. A discussion from 2018 [1] about that indicates a few
adjustments are necessary, but it is not clear whether those
are already implemented with the TPLINK_HEADER_VERSION = 2 or not.

Note that for the TL-WPA8630P v1, the TPLINK_HWID needs to be
changed to 0x86310001 to allow factory flashing.

[1] https://forum.openwrt.org/t/solved-tl-wpa8630p-lede-does-not-install/8161/27

Recovery:

Recovery is only possible via serial.

Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
2020-08-13 20:43:15 +02:00

62 lines
931 B
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
#include "qca9563_tplink_tl-wpa8630.dtsi"
/ {
aliases {
label-mac-device = &eth0;
};
gpio-export {
compatible = "gpio-export";
led_control {
gpio-export,name = "tp-link:led:control";
gpios = <&gpio 14 GPIO_ACTIVE_HIGH>;
};
};
};
&keys {
wps {
label = "WPS button";
linux,code = <KEY_WPS_BUTTON>;
gpios = <&gpio 8 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
};
&partitions {
partition@0 {
label = "factory-uboot";
reg = <0x000000 0x020000>;
read-only;
};
partition@20000 {
label = "u-boot";
reg = <0x020000 0x020000>;
read-only;
};
partition@40000 {
compatible = "tplink,firmware";
label = "firmware";
reg = <0x040000 0x5e0000>;
};
partition@620000 {
label = "partition-table";
reg = <0x620000 0x010000>;
read-only;
};
};
&eth0 {
mtd-mac-address = <&mac 0x8>;
};
&wmac {
mtd-mac-address = <&mac 0x8>;
};