openwrt/target/linux/ramips
David Bauer 14e0e4f138 ramips: add support for ASUS RT-AC57U
SoC:   MediaTek MT7621AT
RAM:   128M (Winbond W631GG6KB-15)
FLASH: 16MB (Spansion S25FL128SA)
WiFi:  MediaTek MT7603EN bgn 2SS
WiFi:  MediaTek MT7612EN nac 2SS
BTN:   Reset - WPS
LED:    - Power
        - LAN {1-4}
        - WAN
        - WiFi 2.4 GHz
        - WiFi 5 GHz
        - USB
UART:  UART is present next to the Power LED.
       TX - RX - GND - 3V3 / 57600-8N1
       3V3 is the nearest one to the Power LED.

Installation
------------
Via TFTP:
1. Set your computers IP-Address to 192.168.1.75.
2. Power up the Router with the Reset button pressed.
3. Release the Reset button after 5 seconds.
4. Upload OpenWRT sysupgrade image via TFTP:
 > tftp -4 -v -m binary 192.168.1.1 -c put <IMAGE>

Via SSH:
Note: User/password for SSH is identical with the one used in the
Web-interface.
1. Complete the initial setup wizard.
2. Activate SSH under "Administration" -> "System".
3. Transfer the OpenWrt sysupgrade image via scp:
 > scp owrt.bin admin@192.168.1.1:/tmp
4. Connect via SSH to the router.
 > ssh admin@192.168.1.1
5. Write the OpenWrt image to flash.
 > mtd-write -i /tmp/owrt.bin -d linux
6. Reboot the router
 > reboot

Signed-off-by: David Bauer <mail@david-bauer.net>
2019-07-11 21:32:39 +02:00
..
base-files ramips: add support for ASUS RT-AC57U 2019-07-11 21:32:39 +02:00
dts ramips: add support for ASUS RT-AC57U 2019-07-11 21:32:39 +02:00
files-4.14/drivers ramips: mt7620: add EPHY base mdio address changing possibility 2019-06-20 08:48:19 +02:00
image ramips: add support for ASUS RT-AC57U 2019-07-11 21:32:39 +02:00
mt76x8 ramips: use upstream RAW_APPENDED_DTB instead of our OWRTDTB 2019-07-08 22:00:24 +02:00
mt7620 ramips: use upstream RAW_APPENDED_DTB instead of our OWRTDTB 2019-07-08 22:00:24 +02:00
mt7621 ramips: use upstream RAW_APPENDED_DTB instead of our OWRTDTB 2019-07-08 22:00:24 +02:00
patches-4.14 ramips: mt7621: add support for memory detection 2019-07-11 22:11:21 +08:00
rt288x ramips: disable CONFIG_MTD_SPLIT_FIRMWARE 2019-01-26 21:46:33 +01:00
rt305x ramips: use upstream RAW_APPENDED_DTB instead of our OWRTDTB 2019-07-08 22:00:24 +02:00
rt3883 ramips: use upstream RAW_APPENDED_DTB instead of our OWRTDTB 2019-07-08 22:00:24 +02:00
Makefile ramips: switch to linux 4.14 2018-04-06 18:07:43 +02:00
modules.mk kernel: Fix kmod-regmap split 2019-01-27 11:07:14 +01:00