Hannu Nyman 7b74b40fe9 ipq806x: remove "firmware" partition definition from netgear routers ... Remove the "firmware" partition definition from the DTS of R7800 to fix sysupgrade. Commit 4645a6d3 defined CONFIG_MTD_SPLIT_UIMAGE_FW=y for ipq806x and that causes mtd to misbehave as additional kernel and ubi partitions are detected from inside the "firmware" partition. [ 1.111324] 0x000001480000-0x000001880000 : "kernel" [ 1.121005] 0x000001880000-0x000007900000 : "ubi" [ 1.283912] 0x000007900000-0x000008000000 : "reserve" [ 1.296407] 0x000001480000-0x000007900000 : "firmware" [ 1.468043] no rootfs found after FIT image in "firmware" [ 2.426860] 2 uimage-fw partitions found on MTD device firmware [ 2.426931] 0x000001480000-0x000001880000 : "kernel" [ 2.440420] 0x000001880000-0x000007900000 : "ubi" Both kernel and ubi are already defined in DTS, so this duplication leads into errors in sysupgrade: Writing from <stdin> to kernel ... ubiattach: error!: strtoul: unable to parse the number '6 mtd10' ubiattach: error!: bad MTD device number: "6 mtd10" The partition is defined to same area as kernel+ubi, and is not needed for sysupgrade anymore. Remove it to fix things. Only tested for the R7800 but all of them should behave equal. Fixes: FS#1617 Signed-off-by: Hannu Nyman <hannu.nyman@iki.fi> [squashed commits, add "tested on" note] Signed-off-by: Mathias Kresin <dev@kresin.me>		2018-06-27 22:11:06 +02:00
..
base-files	ipq806x: add support for NEC Aterm WG2600HP	2018-06-19 20:46:01 +02:00
files-4.14/arch/arm/boot/dts	ipq806x: remove "firmware" partition definition from netgear routers	2018-06-27 22:11:06 +02:00
image	ipq806x: add support for NEC Aterm WG2600HP	2018-06-19 20:46:01 +02:00
patches-4.14	kernel: bump 4.14 to 4.14.51	2018-06-26 08:57:21 +02:00
profiles	ipq806x: enable ath10k firmware for 988x, 99x0 and 9984 by default	2016-07-04 11:41:32 +02:00
config-4.14	ipq806x: add support for NEC Aterm WG2600HP	2018-06-19 20:46:01 +02:00
Makefile	ipq806x: switch to linux 4.14	2018-05-22 20:34:14 +02:00