openwrt/target/linux/ath79
Paul Maruhn 7e4de89e63 ath79: support for TP-Link EAP225-Outdoor v3
This model is almost identical to the EAP225-Outdoor v1.
Major difference is the RTL8211FS PHY Chipset.

Device specifications:
* SoC: QCA9563 @ 775MHz
* Memory: 128MiB DDR2
* Flash: 16MiB SPI-NOR
* Wireless 2.4GHz (SoC): b/g/n 2x2
* Wireless 5GHz (QCA9886): a/n/ac 2x2 MU-MIMO
* Ethernet (RTL8211FS): 1× 1GbE, PoE

Flashing instructions:
* ssh into target device with recent (>= v1.6.0) firmware
* run `cliclientd stopcs` on target device
* upload factory image via web interface

Debricking:
To recover the device, you need access to the serial port. This requires
fine soldering to test points, or the use of probe pins.
* Open the case and solder wires to the test points: RXD, TXD and TPGND4
  * Use a 3.3V UART, 115200 baud, 8n1
* Interrupt bootloader by holding ctrl+B during boot
* upload initramfs via built-in tftp client and perform sysupgrade
    setenv ipaddr 192.168.1.1 # default, change as required
    setenv serverip 192.168.1.10 # default, change as required
    tftp 0x80800000 initramfs.bin
    bootelf $fileaddr

MAC addresses:
MAC address (as on device label) is stored in device info partition at
an offset of 8 bytes. ath9k device has same address as ethernet, ath10k
uses address incremented by 1.
From stock ifconfig:

    ath0      Link encap:Ethernet  HWaddr D8:...:2E
    ath10     Link encap:Ethernet  HWaddr D8:...:2F
    br0       Link encap:Ethernet  HWaddr D8:...:2E
    eth0      Link encap:Ethernet  HWaddr D8:...:2E

Signed-off-by: Paul Maruhn <paulmaruhn@posteo.de>
Co-developed-by: Philipp Rothmann <philipprothmann@posteo.de>
Signed-off-by: Philipp Rothmann <philipprothmann@posteo.de>
[Add pre-calibraton nvme-cells]
Tested-by: Tido Klaassen <tido_ff@4gh.eu>
Signed-off-by: Nick Hainke <vincent@systemli.org>
2022-06-22 17:47:11 +02:00
..
base-files/etc/hotplug.d/ieee80211 ath79: migrate Archer C5 5GHz radio device paths 2022-03-31 18:07:29 +02:00
dts ath79: support for TP-Link EAP225-Outdoor v3 2022-06-22 17:47:11 +02:00
files ath79: ag71xx-mdio: remove phy-mask property 2022-06-15 20:07:26 +02:00
generic ath79: support for TP-Link EAP225-Outdoor v3 2022-06-22 17:47:11 +02:00
image ath79: support for TP-Link EAP225-Outdoor v3 2022-06-22 17:47:11 +02:00
mikrotik ath79: add support for MikroTik hAP (RB951Ui-2nD) 2022-05-21 13:54:08 +02:00
nand ath79: add support for Netgear PGZNG1 2022-06-19 12:31:02 +02:00
patches-5.10 kernel: bump 5.10 to 5.10.119 2022-06-06 19:20:02 +02:00
patches-5.15 kernel: bump 5.15 to 5.15.41 2022-06-06 19:20:28 +02:00
tiny ath79: move ubnt-xm to tiny 2022-06-11 21:22:58 +02:00
config-5.10 ath79: add support for reset key on MikroTik RB912UAG-2HPnD 2022-01-19 16:40:12 +01:00
config-5.15 kernel: move some symbols to generic config 2022-04-09 19:31:46 +02:00
Makefile ath79: switch to Kernel 5.10 2021-12-21 21:38:52 +01:00
modules.mk