openwrt/target/linux/ath79
Nick Hainke 88527294cd ath79: add Netgear WNDAP360
SoC: Atheros AR7161
RAM: DDR 128 MiB (hynix h5dU5162ETR-E3C)
Flash: SPI-NOR 8 MiB (mx25l6406em2i-12g)
WLAN: 2.4/5 GHz
2.4 GHz: Atheros AR9220
5 GHz: Atheros AR9223
Ethernet: 4x 10/100/1000 Mbps (Atheros AR8021)
LEDs/Keys: 2/2 (Internet + System LED, Mesh button + Reset pin)
UART: RJ45 9600,8N1
Power: 12 VDC, 1.0 A

Installation instruction:
0. Make sure you have latest original firmware (3.7.11.4)
1. Connect to the Serial Port with a Serial Cable RJ45 to DB9/RS232
   (9600,8N1)
   screen  /dev/ttyUSB0 9600,cs8,-parenb,-cstopb,-hupcl,-crtscts,clocal
2. Configure your IP-Address to 192.168.1.42
3. When device boots hit spacebar
3. Configure the device for tftpboot
   setenv ipaddr 192.168.1.1
   setenv serverip 192.168.1.42
   saveenv
4. Reset the device
   reset
5. Hit again the spacebar
6. Now load the image via tftp:
   tftpboot 0x81000000 INITRAMFS.bin
7. Boot the image:
   bootm 0x81000000
8. Copy the squashfs-image to the device.
9. Do a sysupgrade.

https://openwrt.org/toh/netgear/wndap360

The device should be converted from kmod-owl-loader to nvmem-cells in the
future. Nvmem cells were not working. Maybe ATH9K_PCI_NO_EEPROM is missing.
That is why this commit is still using kmod-owl-loader. In the future
the device tree may look like this:

&ath9k0 {
       nvmem-cells = <&macaddr_art_120c>, <&cal_art_1000>;
       nvmem-cell-names = "mac-address", "calibration";
};

&ath9k1 {
       nvmem-cells = <&macaddr_art_520c>, <&cal_art_5000>;
       nvmem-cell-names = "mac-address", "calibration";
};

&art {
	...
	cal_art_1000: cal@1000 {
		reg = <0x1000 0xeb8>;
	};

	cal_art_5000: cal@5000 {
		reg = <0x5000 0xeb8>;
	};
};

Signed-off-by: Nick Hainke <vincent@systemli.org>
2022-04-30 23:56:47 +02:00
..
base-files/etc/hotplug.d/ieee80211 ath79: migrate Archer C5 5GHz radio device paths 2022-03-31 18:07:29 +02:00
dts ath79: add Netgear WNDAP360 2022-04-30 23:56:47 +02:00
files ath79: add support for reset key on MikroTik RB912UAG-2HPnD 2022-01-19 16:40:12 +01:00
generic ath79: add Netgear WNDAP360 2022-04-30 23:56:47 +02:00
image ath79: add Netgear WNDAP360 2022-04-30 23:56:47 +02:00
mikrotik ath79: add support for MikroTik RouterBOARD wAP-2nD (wAP) 2022-04-18 07:24:09 +02:00
nand ath79: nand: add 5.15 support for nand subtarget 2022-04-13 12:00:22 +02:00
patches-5.10 kernel: bump 5.10 to 5.10.113 2022-04-30 21:27:45 +02:00
patches-5.15 kernel: bump 5.15 to 5.15.35 2022-04-23 20:46:25 +02:00
tiny ath79: Move TPLink WPA8630Pv2 to ath79-tiny target 2022-04-09 19:31:46 +02:00
config-5.10 ath79: add support for reset key on MikroTik RB912UAG-2HPnD 2022-01-19 16:40:12 +01:00
config-5.15 kernel: move some symbols to generic config 2022-04-09 19:31:46 +02:00
Makefile ath79: switch to Kernel 5.10 2021-12-21 21:38:52 +01:00
modules.mk