openwrt/target/linux
Leon M. Busch-George 74df6ce9db mediatek: filogic: add support for Cudy M3000 v1
Hardware:
  SoC:     MT7981b
  RAM:     256 MB
  Flash:   128 MB SPI NAND
  Ethernet:
    1x 2.5Gbps (rtl8221b)
    1x 1Gbps (integrated phy)
  WiFi:    2x2 MT7981
  Buttons: Reset, WPS
  LED:     1x multicolor

Solder on UART:
  - remove rubber ring on the bottom
  - remove screws
  - pull up the cylinder, maybe help by push on an ethernet socket with a screwdriver
  - remove the (3) screws holding the board in the frame
  - remove the board from the frame to get to the screws for the silver, flat heat shield
  - remove the (3) screws holding the heat shield
  - solder UART pins to the back of the board
    - make sure to have the pins point out on side with the black, finned heat spread
    - the markings for the pins are going to be below the silver heat shield
    - Vcc is not needed

If you don't intend on using the UART outside of the installation process, you might not
want to solder:

  - carefully scrape off the thin layer of epoxy on the holes (not the copper)
  - place your pin header with the UART attached in the holes
  - the pins, starting with the one closest to the socket:
    - Vcc (not required)
    - GND
    - RX
    - TX
  - either wedge the header or hold it with your fingers so that the pins stay in contact with the board

Installation (UART):
  - attach an Ethernet cable to the 1Gbps port (black) on the router
  - hold the reset button while powering the router
  - press CTRL-C or wait for the timeout to get to the U-Boot prompt
  - prepare a TFTP server on the network to supply ..-initramfs-kernel.bin
  - use 'tftpboot' in the U-Boot shell to pull the image
  - boot the image using 'bootm'
  - push the ..-sysupgrade to the router using your preferred method
  - perform the upgrade with 'sysupgrade -n'

There is a recovery mechanism that involves fetching a file called 'recovery.bin' but that is not understood yet.

Signed-off-by: Leon M. Busch-George <leon@georgemail.eu>
(cherry picked from commit 20e4a18feb)
2024-07-15 16:12:33 +02:00
..
airoha kernel: bump 5.15 to 5.15.125 2023-08-10 21:07:50 +02:00
apm821xx apm821xx: WNDR4700: fix broken sysupgrade, factory images 2023-10-21 16:42:26 +02:00
archs38 treewide: remove files for building 5.10 kernel 2023-05-12 13:02:43 +02:00
armsr armsr: add realtek and smsc ethernet phy drivers to the default image 2024-07-06 18:37:39 +02:00
at91 kernel: bump 5.15 to 5.15.157 2024-05-13 14:01:51 +02:00
ath25 kernel: bump 5.15 to 5.15.131 2023-09-25 23:04:37 +02:00
ath79 ath79: replace "mac-address-ascii" with "mac-base" 2024-07-15 09:59:31 +02:00
bcm27xx kernel: bump 5.15 to 5.15.162 2024-07-08 21:26:43 +02:00
bcm47xx kernel: bump 5.15 to 5.15.158 2024-05-13 18:38:23 +03:00
bcm53xx kernel: bump 5.15 to 5.15.162 2024-07-08 21:26:43 +02:00
bcm63xx kernel: bump 5.15 to 5.15.148 2024-02-10 20:19:28 +01:00
bcm4908 kernel: bump 5.15 to 5.15.153 2024-04-01 02:33:05 +02:00
bmips kernel: bump 5.15 to 5.15.162 2024-07-08 21:26:43 +02:00
gemini kernel: bump 5.15 to 5.15.146 2024-01-08 23:15:35 +01:00
generic mediatek: fix WED + wifi reset 2024-07-10 17:31:17 +02:00
imx kernel: backport NVMEM patches queued for the v6.5 2023-07-10 12:54:53 +02:00
ipq40xx ipq40xx: eap1300: add eap1300ext as alt model 2024-07-01 07:14:18 +02:00
ipq806x ipq806x: rt4230w-rev6: fix status reporting via the LEDs 2024-05-23 22:15:33 +02:00
ipq807x kernel: bump 5.15 to 5.15.155 2024-04-30 23:38:26 +02:00
kirkwood kirkwood: fix Ctera C200 V1 ubi part name 2023-12-14 21:40:20 +01:00
lantiq kernel: bump 5.15 to 5.15.162 2024-07-08 21:26:43 +02:00
layerscape kernel: 5.15: backport v6.1 PHY changes required for Aquantia 2024-01-31 11:57:41 +01:00
malta treewide: remove files for building 5.10 kernel 2023-05-12 13:02:43 +02:00
mediatek mediatek: filogic: add support for Cudy M3000 v1 2024-07-15 16:12:33 +02:00
mpc85xx mpc85xx: fix label-mac-address for Enterasys WS-AP3710i 2024-06-16 14:03:03 +02:00
mvebu kernel: bump 5.15 to 5.15.157 2024-05-13 14:01:51 +02:00
mxs mxs: rework image generation 2023-07-06 17:04:13 +02:00
octeon kernel: bump 5.15 to 5.15.145 2024-01-07 12:57:30 +00:00
octeontx kernel: bump 5.15 to 5.15.155 2024-04-30 23:38:26 +02:00
omap treewide: remove files for building 5.10 kernel 2023-05-12 13:02:43 +02:00
oxnas kernel: bump 5.15 to 5.15.157 2024-05-13 14:01:51 +02:00
pistachio kernel: fix mtd/NVMEM regression affecting U-Boot env NVMEM driver 2023-11-02 09:45:08 +01:00
qoriq kernel: fix handling of CONFIG_DYNAMIC_DEBUG 2023-05-03 10:26:17 -07:00
ramips ramips: limit max spi clock frequency to 50 MHz 2024-07-10 23:41:15 +02:00
realtek kernel: bump 5.15 to 5.15.162 2024-07-08 21:26:43 +02:00
rockchip rockchip: remove redundant 'console' parameter from boot script 2024-03-31 20:39:57 +02:00
sifiveu kernel: bump 5.15 to 5.15.153 2024-04-01 02:33:05 +02:00
sunxi sunxi: fix network bringup on Olinuxino Micro boards 2024-04-21 23:26:53 +02:00
tegra tegra: Activate CONFIG_SND_DRIVERS 2024-07-08 21:13:26 +02:00
uml kernel: bump 5.15 to 5.15.132 2023-09-25 23:04:37 +02:00
x86 kernel: bump 5.15 to 5.15.158 2024-05-13 18:38:23 +03:00
zynq generic: enable CONFIG_ARM_CRYPTO for 32bit arm targets 2023-05-10 19:01:45 +02:00
Makefile linux: add dtb makefile target to targets list 2024-02-10 13:29:43 +01:00