openwrt/target/linux/ath79/image
Sander Vanheule c9f51a9ad6 ath79: support for TP-Link EAP225-Wall v2
TP-Link EAP225-Wall v2 is an AC1200 (802.11ac Wave-2) wall plate access
point. UART access and debricking require fine soldering.

The device was kindly provided for porting by Stijn Segers.

Device specifications:
* SoC: QCA9561 @ 775MHz
* RAM: 128MiB DDR2
* Flash: 16MiB SPI-NOR (GD25Q127CSIG)
* Wireless 2.4GHz (SoC): b/g/n, 2x2
* Wireless 5Ghz (QCA9886): a/n/ac, 2x2 MU-MIMO
* Ethernet (SoC): 4× 100Mbps
  * Eth0 (back): 802.3af/at PoE in
  * Eth1, Eth2 (bottom)
  * Eth3 (bottom): PoE out (can be toggled by GPIO)
* One status LED
* Two buttons (both work as failsafe)
  * LED button, implemented as KEY_BRIGHTNESS_TOGGLE
  * Reset button

Flashing instructions, requires recent firmware (tested on 1.20.0):
* ssh into target device and run `cliclientd stopcs`
* Upgrade with factory image via web interface

Debricking:
* Serial port can be soldered on PCB J4 (1: TXD, 2: RXD, 3: GND, 4: VCC)
    * Bridge unpopulated resistors R162 (TXD) and R165 (RXD)
      Do NOT bridge R164
    * Use 3.3V, 115200 baud, 8n1
* Interrupt bootloader by holding CTRL+B during boot
* tftp initramfs to flash via sysupgrade or LuCI web interface

MAC addresses:
MAC address (as on device label) is stored in device info partition at
an offset of 8 bytes. ath9k device has same address as ethernet, ath10k
uses address incremented by 1.
From OEM ifconfig:
    br0       Link encap:Ethernet  HWaddr 50:...:04
    eth0      Link encap:Ethernet  HWaddr 50:...:04
    wifi0     Link encap:UNSPEC  HWaddr 50-...-04-...
    wifi1     Link encap:UNSPEC  HWaddr 50-...-05-...

Signed-off-by: Sander Vanheule <sander@svanheule.net>
[fix IMAGE_SIZE]
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
2020-09-12 19:37:24 +02:00
..
bin ath79: add support for PISEN WMB001N 2019-08-08 21:00:59 +08:00
lzma-loader ath79: move lzma-loader to the end of available RAM 2020-01-23 15:28:03 +01:00
common-buffalo.mk ath79: sort device definitions in image/* 2019-09-21 22:17:39 +02:00
common-mikrotik.mk ath79/mikrotik: create shared device definitions for nor and nand 2020-08-01 18:31:24 +02:00
common-netgear.mk ath79: reorganize common image definitions for Netgear 2020-07-29 12:08:16 +02:00
common-tp-link.mk ath79: replace custom uImageArcher generation 2020-06-29 01:08:09 +02:00
common-yuncore.mk ath79: add support for YunCore TFTP image generation 2019-11-25 17:32:46 +01:00
generic-tp-link.mk ath79: support for TP-Link EAP225-Wall v2 2020-09-12 19:37:24 +02:00
generic-ubnt.mk treewide: use wpad-basic-wolfssl as default 2020-08-20 14:19:39 +02:00
generic.mk ath79: add support for Mercury MW4530R v1 2020-09-12 18:47:26 +02:00
Makefile ath79: drop Build/loader-kernel-cmdline 2020-09-06 19:43:08 +02:00
mikrotik.mk ath79: add support for MikroTik SXT 5nD r2 (SXT Lite5) 2020-08-12 14:03:17 +02:00
nand.mk ath79/nand: add support for Netgear WNDR4300TN 2020-08-06 16:56:07 +02:00
tiny-netgear.mk ath79: disable default build for devices with 4M flash 2020-07-29 12:08:16 +02:00
tiny-tp-link.mk ath79: add support for TP-Link TL-WA901ND v3 2020-08-08 20:40:48 +02:00
tiny.mk ath79: Do not build buffalo_whr-g301n by default 2020-05-21 22:16:17 +02:00