mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-20 14:13:16 +00:00
6492ea7d9e
ALFA Network N2Q is an outdoor N300 AP/CPE based on Qualcomm/Atheros QCA9531 v2. This model is a successor of the old N2 which was based on Atheros AR7240. FCC ID: 2AB8795311. Specifications: - Qualcomm/Atheros QCA9531 v2 - 650/400/200 MHz (CPU/DDR/AHB) - 128 MB of RAM (DDR2) - 16 MB of flash (SPI NOR) - 2T2R 2.4 GHz Wi-Fi with ext. PA (Skyworks SE2623L) and LNA - 2x 10/100 Mbps Ethernet with passive PoE input in one port (24 V) - PoE pass through in second port (controlled by GPIO) - support for optional 802.3af/at PoE module - 1x mini PCIe slot (PCIe bus, extra 4.2 V for high power cards) - 2x IPEX/U.FL connectors on PCB - 1x USB 2.0 mini Type-B (power controlled by GPIO) - 8x LED (7 of them are driven by GPIO) - 1x button (reset) - external h/w watchdog (EM6324QYSP5B, enabled by default) - UART (4-pin, 2.54 mm pitch) header on PCB - LEDs (2x 5-pin, 2.54 mm pitch) header on PCB Flash instruction: You can use sysupgrade image directly in vendor firmware which is based on LEDE/OpenWrt. Alternatively, you can use web recovery mode in U-Boot: 1. Configure PC with static IP 192.168.1.2/24. 2. Connect PC with one of RJ45 ports, press the reset button, power up device, wait for first blink of all LEDs (indicates network setup), then keep button for 3 following blinks and release it. 3. Open 192.168.1.1 address in your browser and upload sysupgrade image. Signed-off-by: Piotr Dymacz <pepe2k@gmail.com> |
||
---|---|---|
.. | ||
apm821xx | ||
arc770 | ||
archs38 | ||
armvirt | ||
at91 | ||
ath25 | ||
ath79 | ||
bcm27xx | ||
bcm47xx | ||
bcm53xx | ||
bcm63xx | ||
gemini | ||
generic | ||
imx6 | ||
ipq40xx | ||
ipq806x | ||
ipq807x | ||
kirkwood | ||
lantiq | ||
layerscape | ||
malta | ||
mediatek | ||
mpc85xx | ||
mvebu | ||
mxs | ||
octeon | ||
octeontx | ||
omap | ||
oxnas | ||
pistachio | ||
ramips | ||
rockchip | ||
rtl838x | ||
sunxi | ||
tegra | ||
uml | ||
x86 | ||
zynq | ||
Makefile |