INAGAKI Hiroshi 643fcfc8d6 ath79: add support for NEC Aterm WG1200CR
NEC Aterm WG1200CR is a 2.4/5 GHz band 11ac router,
based on Qualcomm Atheros QCA9563.

Specification:

- SoC		: Qualcomm Atheros QCA9563
- RAM		: DDR2 128 MiB
- Flash		: SPI-NOR 8 MiB
- WLAN		: 2.4/5 GHz 2T2R
  - 2.4 GHz	: QCA9563 (SoC)
  - 5 GHz	: QCA9888
- Ethernet	: 2x 10/100/1000 Mbps
  - Switch	: QCA8334
- LEDs/Input	: 12x/4x (2x buttons, 1x slide-switch)
- UART		: through-hole on PCB
  - JP1: Vcc, GND, NC, TX, RX from power connector side
  - 115200 bps

Flash instruction using factory image:

1. Boot WG1200CR normaly
2. Access to "http://192.168.10.1/" and open firmware update page
("ファームウェア更新")
3. Select the OpenWrt factory image and click update ("更新") button
to perform firmware update
4. Wait ~150 seconds to complete flashing

Known issues:

- cannot be controlled LEDs other than Power (Green/Red)
  - only Power LEDs are connected to SoC GPIO; other LEDs
    connected to the gpiochip on ath10k chip (QCA9888)

Signed-off-by: INAGAKI Hiroshi <musashino.open@gmail.com>
Signed-off-by: Christian Lamparter <chunkeey@gmail.com> [commit
message formatting]
2019-04-06 19:14:06 +02:00
..
2019-01-28 18:17:32 +01:00
2019-01-28 18:17:32 +01:00
2019-01-28 18:17:32 +01:00
2019-01-27 00:16:13 +01:00
2018-11-05 16:00:00 +01:00
2019-03-22 18:14:28 +01:00
2019-03-22 18:14:28 +01:00
2019-03-27 10:48:59 +01:00
2019-02-14 16:45:01 +01:00
2019-04-06 14:48:46 +02:00
2019-03-22 18:14:28 +01:00
2019-03-27 10:48:59 +01:00
2019-02-25 17:33:16 +01:00
2019-03-27 10:48:59 +01:00
2019-03-27 10:48:59 +01:00
2019-01-13 16:31:40 +01:00
2018-08-20 13:03:23 +02:00
2019-02-14 16:45:01 +01:00
2019-03-11 19:35:43 +01:00
2018-10-09 14:29:55 +02:00
2018-10-19 10:01:57 +02:00
2019-03-27 10:48:59 +01:00
2019-01-07 17:09:06 +01:00
2018-12-10 11:48:44 +01:00
2019-04-06 14:48:46 +02:00
2018-08-20 13:03:23 +02:00