Abdul Aziz Amar 3b3dccae0e ramips: add support for BOLT! Arion ... This device is from now-defunct BOLT! ISP in Indonesia. The original firmware is based on mediatek SDK running linux 2.6 or 3.x in later revision. Specifications: - SoC: MediaTek MT7621 - Flash: 32 MiB NOR SPI - RAM: 128 MiB DDR3 - Ethernet: 2x 10/100/1000 Mbps (switched, LAN + WAN) - WIFI0: MT7603E 2.4GHz 802.11b/g/n - WIFI1: MT7612E 5GHz 802.11ac - Antennas: 2x internal, non-detachable - LEDs: Programmable LEDs: 5 blue LEDs (wlan, tel, sig1-3) and 2 red LEDs (wlan and sig1) Non-programmable "Power" LED - Buttons: Reset and WPS Instalation: Install from TFTP Set your PC IP to 10.10.10.3 and gateway to 10.10.10.123 Press "1" when turning on the router, and type the initramfs file name You also need to solder pin header or cable to J4 or neighboring test points (T19-T21) Pinouts from top to bottom: GND, TX, RX, VCC (3.3v) Baudrate: 57600n8 There's also an additional gigabit transformer and RTL8211FD managed by the LTE module on the backside of the PCB. Signed-off-by: Abdul Aziz Amar <abdulaziz.amar@gmail.com> (cherry picked from commit 78c3534645)		2022-04-19 21:45:46 +02:00
..
board.d	ramips: add support for BOLT! Arion	2022-04-19 21:45:46 +02:00
hotplug.d/ieee80211	ramips: add support for Beeline SmartBox Flash	2022-03-19 16:14:01 +01:00
init.d	ramips: add support for Linksys EA6350 v4	2022-01-08 00:49:59 +01:00
uci-defaults	ramips: remove model name from LED labels	2020-10-02 14:51:57 +02:00