mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-22 06:57:57 +00:00
47f5a0a3ee
The GS1900-48 is a 48 + 2 port Gigabit L2 switch with 48 gigabit ports.
Hardware:
RTL8393M SoC
Macronix MX25l12805D (16MB flash)
128MB RAM
6 * RTL8218B external PHY
2 * RTL8231 GPIO extenders to control the port LEDs, system LED and
Reset button
2 Uplink ports are SFP cages which support 1000 Base-X mini GBIC modules.
Power is supplied via a 230 volt mains connector.
The board has a hard reset switch SW1, which is is not reachable from the outside.
J4 provides a 12V RS232 serial connector which is connected through U8 to
the 3.3V UART of the RTL8393. Conversion is done by U8, a SIPEX 3232EC.
To connect to the UART, wires can be soldered to R603 (TX) and R602 (RX).
Installation:
Install the squashfs image via Realtek's original Web-Interface.
Signed-off-by: Birger Koblitz <git@birger-koblitz.de>
25 lines
525 B
Makefile
25 lines
525 B
Makefile
# SPDX-License-Identifier: GPL-2.0-only
|
|
|
|
include $(TOPDIR)/rules.mk
|
|
|
|
ARCH:=mips
|
|
BOARD:=realtek
|
|
BOARDNAME:=Realtek MIPS
|
|
DEVICE_TYPE:=basic
|
|
FEATURES:=ramdisk squashfs
|
|
SUBTARGETS:=rtl838x rtl839x
|
|
|
|
KERNEL_PATCHVER:=5.10
|
|
|
|
define Target/Description
|
|
Build firmware images for Realtek RTL83xx based boards.
|
|
endef
|
|
|
|
include $(INCLUDE_DIR)/target.mk
|
|
|
|
DEFAULT_PACKAGES += uboot-envtools ethtool kmod-gpio-button-hotplug \
|
|
dnsmasq firewall ip6tables iptables odhcp6c odhcpd-ipv6only \
|
|
ip-full ip-bridge tc
|
|
|
|
$(eval $(call BuildTarget))
|