mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-21 14:37:57 +00:00
9703a2adcc
Refresh all patches on top of kernel 5.10.138. The following patches were applied upstream: bcm27xx/patches-5.10/950-0311-drm-vc4-Adopt-the-dma-configuration-from-the-HVS-or-.patch bcm27xx/patches-5.10/950-0317-vc4_hdmi-Remove-firmware-logic-for-MAI-threshold-set.patch bcm27xx/patches-5.10/950-0346-drm-vc4-A-present-but-empty-dmas-disables-audio.patch bcm27xx/patches-5.10/950-0354-drm-vc4-Add-the-2711-HVS-as-a-suitable-DMA-node.patch bcm27xx/patches-5.10/950-0413-drm-vc4-hdmi-Don-t-access-the-connector-state-in-res.patch bcm27xx/patches-5.10/950-0505-vc4-drm-Avoid-full-hdmi-audio-fifo-writes.patch bcm27xx/patches-5.10/950-0512-vc4-drm-vc4_plane-Remove-subpixel-positioning-check.patch bcm27xx/patches-5.10/950-0560-drm-vc4-drv-Remove-the-DSI-pointer-in-vc4_drv.patch bcm27xx/patches-5.10/950-0561-drm-vc4-dsi-Use-snprintf-for-the-PHY-clocks-instead-.patch bcm27xx/patches-5.10/950-0562-drm-vc4-dsi-Introduce-a-variant-structure.patch bcm27xx/patches-5.10/950-0565-drm-vc4-Correct-pixel-order-for-DSI0.patch bcm27xx/patches-5.10/950-0566-drm-vc4-Register-dsi0-as-the-correct-vc4-encoder-typ.patch bcm27xx/patches-5.10/950-0567-drm-vc4-Fix-dsi0-interrupt-support.patch bcm27xx/patches-5.10/950-0568-drm-vc4-Add-correct-stop-condition-to-vc4_dsi_encode.patch bcm27xx/patches-5.10/950-0647-drm-vc4-Fix-timings-for-interlaced-modes.patch bcm27xx/patches-5.10/950-0695-drm-vc4-Fix-margin-calculations-for-the-right-bottom.patch Upstream sets the pixel clock to 340MHz now, do not set it to 600MHz any more. bcm27xx/patches-5.10/950-0576-drm-vc4-hdmi-Raise-the-maximum-clock-rate.patch Fixes:89956c6532("kernel: bump 5.10 to 5.10.138") Fixes:4209c33ae2("kernel: bump 5.10 to 5.10.137") Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
44 lines
1.7 KiB
Diff
44 lines
1.7 KiB
Diff
From 23771cfafeedba325b6e9d7dedde11eb25381d67 Mon Sep 17 00:00:00 2001
|
|
From: Maxime Ripard <maxime@cerno.tech>
|
|
Date: Mon, 14 Jun 2021 15:27:24 +0200
|
|
Subject: [PATCH] drm/vc4: crtc: Add encoder to vc4_crtc_config_pv
|
|
prototype
|
|
|
|
vc4_crtc_config_pv() retrieves the encoder again, even though its only
|
|
caller, vc4_crtc_atomic_enable(), already did.
|
|
|
|
Pass the encoder pointer as an argument instead of going through all the
|
|
connectors to retrieve it again.
|
|
|
|
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
|
|
---
|
|
drivers/gpu/drm/vc4/vc4_crtc.c | 7 +++----
|
|
1 file changed, 3 insertions(+), 4 deletions(-)
|
|
|
|
--- a/drivers/gpu/drm/vc4/vc4_crtc.c
|
|
+++ b/drivers/gpu/drm/vc4/vc4_crtc.c
|
|
@@ -313,12 +313,11 @@ static void vc4_crtc_pixelvalve_reset(st
|
|
CRTC_WRITE(PV_CONTROL, CRTC_READ(PV_CONTROL) | PV_CONTROL_FIFO_CLR);
|
|
}
|
|
|
|
-static void vc4_crtc_config_pv(struct drm_crtc *crtc, struct drm_atomic_state *state)
|
|
+static void vc4_crtc_config_pv(struct drm_crtc *crtc, struct drm_encoder *encoder,
|
|
+ struct drm_atomic_state *state)
|
|
{
|
|
struct drm_device *dev = crtc->dev;
|
|
struct vc4_dev *vc4 = to_vc4_dev(dev);
|
|
- struct drm_encoder *encoder = vc4_get_crtc_encoder(crtc, state,
|
|
- drm_atomic_get_new_connector_state);
|
|
struct vc4_encoder *vc4_encoder = to_vc4_encoder(encoder);
|
|
struct vc4_crtc *vc4_crtc = to_vc4_crtc(crtc);
|
|
const struct vc4_pv_data *pv_data = vc4_crtc_to_vc4_pv_data(vc4_crtc);
|
|
@@ -582,7 +581,7 @@ static void vc4_crtc_atomic_enable(struc
|
|
if (vc4_encoder->pre_crtc_configure)
|
|
vc4_encoder->pre_crtc_configure(encoder, state);
|
|
|
|
- vc4_crtc_config_pv(crtc, state);
|
|
+ vc4_crtc_config_pv(crtc, encoder, state);
|
|
|
|
CRTC_WRITE(PV_CONTROL, CRTC_READ(PV_CONTROL) | PV_CONTROL_EN);
|
|
|