openwrt/target/linux/ath79
David Bauer b7da0d2944 ath79: add support for Ubiquiti UniFi AP Pro
This adds support for the Ubiquiti UniFi AP Pro to the ath79 target. The
device was previously supported on the now removed ar71xx target.

SoC   Atheros AR9344
WiFi  Atheros AR9344 & Atheros AR9280
ETH   Atheros AR8327
RAM   128M DDR2
FLASH 16M SPI-NOR

Installation
------------

Follow the Ubiquiti TFTP recovery procedure for this device.

1. Hold down the reset button while connecting power for 10 seconds.
2. Transfer the factory image via TFTP to the AP (192.168.1.20)
3. Wait 2 minutes for the AP to write the firmware to flash. The device
   will automatically reboot to OpenWrt.

Signed-off-by: David Bauer <mail@david-bauer.net>
2020-09-17 18:07:39 +02:00
..
base-files/etc/hotplug.d/ieee80211 ath79: add mikrotik subtarget 2020-03-17 11:50:47 +01:00
dts ath79: add support for Ubiquiti UniFi AP Pro 2020-09-17 18:07:39 +02:00
files kernel: Update kernel 4.19 to version 4.19.131 2020-07-04 21:12:42 +02:00
generic ath79: add support for Ubiquiti UniFi AP Pro 2020-09-17 18:07:39 +02:00
image ath79: add support for Ubiquiti UniFi AP Pro 2020-09-17 18:07:39 +02:00
mikrotik treewide: use wpad-basic-wolfssl as default 2020-08-20 14:19:39 +02:00
nand treewide: use wpad-basic-wolfssl as default 2020-08-20 14:19:39 +02:00
patches-4.19 kernel: Update kernel 4.19 to version 4.19.138 2020-08-10 19:34:37 +02:00
patches-5.4 kernel: bump 5.4 to 5.4.58 2020-08-18 18:14:54 +02:00
tiny treewide: use wpad-basic-wolfssl as default 2020-08-20 14:19:39 +02:00
config-4.19 ath79: enable elf mtd splitter 2020-09-09 20:41:50 +03:00
config-5.4 ath79: enable elf mtd splitter 2020-09-09 20:41:50 +03:00
Makefile ath79: switch to kernel 5.4 2020-07-07 10:33:17 +02:00
modules.mk ath79: add new OF only target for QCA MIPS silicon 2018-05-07 08:06:51 +02:00