INAGAKI Hiroshi 61e8728d86 ramips: add support for ELECOM WMC-S1267GS2 ... ELECOM WMC-S1267GS2 is a 2.4/5 GHz band 11ac (Wi-Fi 5) mesh extender, based on MT7621A. This device has almost the same hardware as WMC-M1267GST2. Specification: - SoC : MediaTek MT7621A - RAM : DDR3 256 MiB (Nanya NT5CC128M16JR-EK) - Flash : SPI-NOR 32 MiB (Winbond W25Q256JVFIQ) - WLAN : 2.4/5 GHz 2T2R (MediaTek MT7615D) - Ethernet : 10/100/1000 Mbps x4 - switch : MediaTek MT7530 (SoC) - LEDs/Keys : 6x/6x - UART : through-hole on PCB ("J4") - arrangement: 3.3V, GND, TX, RX from tri-angle marking - settings : 57600n8 - Power : 12 VDC, 1 A Flash instruction using factory image: 1. Boot WMC-S1267GS2 normally 2. Set IP address of the computer to 192.168.2.x 3. Access to "http://192.168.2.1/" and open firmware update page ("ファームウェア更新") 4. Select the OpenWrt factory image and click apply ("適用") button 5. Wait ~120 seconds to complete flashing MAC addresses: LAN : 04:AB:18:xx:xx:9E (Factory, 0xFFF4 (hex)) 2.4 GHz: 04:AB:18:xx:xx:9F 5 GHz : 04:AB:18:xx:xx:A0 (Factory, 0x4 (hex)) Signed-off-by: INAGAKI Hiroshi <musashino.open@gmail.com>		2024-05-11 19:33:28 +02:00
..
board.d	ramips: add support for ELECOM WMC-S1267GS2	2024-05-11 19:33:28 +02:00
hotplug.d	ramips: Add support for D-Link DIR-3040 A1	2024-04-14 20:34:36 +02:00
init.d	ramips: add support for JDCloud RE-CP-02	2024-05-11 17:24:10 +02:00
rc.button	ramips: enable LED button for TP-Link EC330-G5u v1	2023-06-08 17:25:22 +02:00
uci-defaults	ramips: use function/color syntax for some dlink dir routers	2024-05-09 22:24:31 +02:00