openwrt/target
Birger Koblitz 47f5a0a3ee realtek: Add support for ZyXEL GS1900-48 Switch
The GS1900-48 is a 48 + 2 port Gigabit L2 switch with 48 gigabit ports.
Hardware:
    RTL8393M SoC
    Macronix MX25l12805D (16MB flash)
    128MB RAM
    6 * RTL8218B external PHY
    2 * RTL8231 GPIO extenders to control the port LEDs, system LED and
    Reset button

2 Uplink ports are SFP cages which support 1000 Base-X mini GBIC modules.

Power is supplied via a 230 volt mains connector.
The board has a hard reset switch SW1, which is is not reachable from the outside.
J4 provides a 12V RS232 serial connector which is connected through U8 to
the 3.3V UART of the RTL8393. Conversion is done by U8, a SIPEX 3232EC.
To connect to the UART, wires can be soldered to R603 (TX)  and R602 (RX).

Installation:
Install the squashfs image via Realtek's original Web-Interface.

Signed-off-by: Birger Koblitz <git@birger-koblitz.de>
2022-02-17 15:21:47 +00:00
..
imagebuilder imagebuilder: fix local packages/ folder 2021-11-05 19:18:48 -10:00
linux realtek: Add support for ZyXEL GS1900-48 Switch 2022-02-17 15:21:47 +00:00
llvm-bpf llvm-bpf: fix rebuild check for generating tarball 2021-11-26 11:37:19 +01:00
sdk sdk: ship llvm toolchain 2022-01-27 11:32:56 +01:00
toolchain toolchain: switch packaged toolchain to tar.xz 2021-10-21 08:25:38 -10:00
Config.in base-files: add eMMC sysupgrade support 2021-12-02 20:42:58 +00:00
Makefile tools/llvm-bpf: move tarball packing to target/llvm-bpf 2021-11-22 12:00:40 +01:00