mirror of
https://github.com/openwrt/openwrt.git
synced 2024-12-26 00:41:17 +00:00
f0a5f24217
- two upstreamed patches removed - compile tested all targets using 4.1 - run tested ar71xx Signed-off-by: Roman Yeryomin <roman@advem.lv> Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 47694
42 lines
1.8 KiB
Diff
42 lines
1.8 KiB
Diff
From 69b78182d6d7777153323abe3cff8e533ca01143 Mon Sep 17 00:00:00 2001
|
|
From: Hongzhou Yang <hongzhou.yang@mediatek.com>
|
|
Date: Mon, 18 May 2015 23:11:12 -0700
|
|
Subject: [PATCH 48/76] dt-bindings: mediatek: Modify pinctrl bindings for
|
|
mt6397.
|
|
|
|
Since 6397 is no need to support interrupt controller,
|
|
moving interrupt controller relate property to optional list.
|
|
Also adding mt8173 and mt8127 to bindings.
|
|
|
|
Signed-off-by: Hongzhou Yang <hongzhou.yang@mediatek.com>
|
|
---
|
|
Documentation/devicetree/bindings/pinctrl/pinctrl-mt65xx.txt | 9 +++++++--
|
|
1 file changed, 7 insertions(+), 2 deletions(-)
|
|
|
|
--- a/Documentation/devicetree/bindings/pinctrl/pinctrl-mt65xx.txt
|
|
+++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-mt65xx.txt
|
|
@@ -3,9 +3,11 @@
|
|
The Mediatek's Pin controller is used to control SoC pins.
|
|
|
|
Required properties:
|
|
-- compatible: value should be either of the following.
|
|
+- compatible: value should be one of the following.
|
|
(a) "mediatek,mt8135-pinctrl", compatible with mt8135 pinctrl.
|
|
-- mediatek,pctl-regmap: Should be a phandle of the syscfg node.
|
|
+ (b) "mediatek,mt8173-pinctrl", compatible with mt8173 pinctrl.
|
|
+ (c) "mediatek,mt6397-pinctrl", compatible with mt6397 pinctrl.
|
|
+ (d) "mediatek,mt8127-pinctrl", compatible with mt8127 pinctrl.
|
|
- pins-are-numbered: Specify the subnodes are using numbered pinmux to
|
|
specify pins.
|
|
- gpio-controller : Marks the device node as a gpio controller.
|
|
@@ -24,6 +26,9 @@ Required properties:
|
|
Only the following flags are supported:
|
|
0 - GPIO_ACTIVE_HIGH
|
|
1 - GPIO_ACTIVE_LOW
|
|
+
|
|
+Optional properties:
|
|
+- mediatek,pctl-regmap: Should be a phandle of the syscfg node.
|
|
- reg: physicall address base for EINT registers
|
|
- interrupt-controller: Marks the device node as an interrupt controller
|
|
- #interrupt-cells: Should be two.
|