Roger Pueyo Centelles 4387fe00cb ath79: mikrotik: enable SFP on RB922UAGS-5HPaCD ... This patch enables the SFP cage on the MikroTik RouterBOARD 922UAGS-5HPacD. GPIO16 (tx-disable-gpios) should be governed by the SFP driver to enable or disable transmission, but no change is observed. Therefore, it is left as output high to ensure the SFP module is forced to transmit. Tested on a RouterBOARD 922UAGS-5HPacD board, with a CISCO GLC-LH-SMD 1310nm module and an unbranded GLC-T RJ45 Gigabit module. PC=>router iperf3 tests deliver 440/300 Mbps up/down, both via regular eth0 port or SFP port with RJ45 module. Bridge between eth0 and eth1 delivers 950 Mbps symmetric. Signed-off-by: Roger Pueyo Centelles <roger.pueyo@guifi.net>		2021-04-16 13:54:22 +02:00
..
base-files/etc/hotplug.d/ieee80211	ath79: add WiFi migration for AR913x	2020-09-28 16:23:03 +02:00
dts	ath79: mikrotik: enable SFP on RB922UAGS-5HPaCD	2021-04-16 13:54:22 +02:00
files	ath79: force SGMII SerDes mode to MAC operation	2021-04-13 00:32:56 +02:00
generic	ath79: consolidate testing kernel	2021-04-10 19:28:04 +02:00
image	ath79: mikrotik: enable SFP on RB922UAGS-5HPaCD	2021-04-16 13:54:22 +02:00
mikrotik	ath79: mikrotik: enable SFP on RB922UAGS-5HPaCD	2021-04-16 13:54:22 +02:00
nand	ath79: consolidate testing kernel	2021-04-10 19:28:04 +02:00
patches-5.4	ath79: force SGMII SerDes mode to MAC operation	2021-04-13 00:32:56 +02:00
patches-5.10	ath79: add missing patch for kernel 5.10	2021-04-13 00:40:38 +02:00
tiny	ath79: consolidate testing kernel	2021-04-10 19:28:04 +02:00
config-5.4	ath79: enable Regulator support for target	2021-02-22 00:57:25 +01:00
config-5.10	ath79: enable AT803X PHY for kernel 5.10	2021-03-05 00:03:57 +01:00
Makefile	ath79: consolidate testing kernel	2021-04-10 19:28:04 +02:00
modules.mk	ath79: add new OF only target for QCA MIPS silicon	2018-05-07 08:06:51 +02:00